AD 98-17-03 ACTIVE

This amendment adopts a new airworthiness directive (AD) that applies to all Glaser-Dirks Flugzeugbau GmbH (Glaser-Dirks) Model DG-400 gliders. This AD requires replacing the propeller shaft, the bearings, and the front drive belt retaining rings with ones of improved design. This AD is the result of mandatory continuing airworthiness information (MCAI) issued by the airworthiness authority for Germany. The actions specified by this AD are intended to prevent failure of the propeller shaft caused by an ineffective design, which could result in loss of glider propulsion during critical phases of flight.

Final rule

98-17-03 GLASER-DIRKS FLUGZEUGBAU GMBH: Amendment 39-10705; Docket No. 98-CE-07-AD.
Applicability: Model DG-400 gliders, all serial numbers, certificated in any category.

NOTE 1: This AD applies to each glider identified in the preceding applicability provision, regardless of whether it has been modified, altered, or repaired in the area subject to the requirements of this AD. For gliders that have been modified, altered, or repaired so that the performance of the requirements of this AD is affected, the owner/operator must request approval for an alternative method of compliance in accordance with paragraph (c) of this AD. The request should include an assessment of the effect of the modification, alteration, or repair on the unsafe condition addressed by this AD; and, if the unsafe condition has not been eliminated, the request should include specific proposed actions to address it.

Compliance: Required within the next 4 calendar months after the effective date of this AD, unless already accomplished.

To prevent failure of the propeller shaft caused by an ineffective design, which could result in loss of glider propulsion during critical phases of flight, accomplish the following:

(a) Replace the propeller shaft, the bearings, and the front drive belt retaining rings with parts of improved design in accordance with paragraph 2 of the Instructions section of DG Flugzeugbau Technical Note No. 826/32, dated July 19, 1996, and WORKING INSTRUCTION No. 1 for TN 826/32, dated July, 1996.

(b) Special flight permits may be issued in accordance with sections 21.197 and 21.199 of the Federal Aviation Regulations (14 CFR 21.197 and 21.199) to operate the glider to a location where the requirements of this AD can be accomplished.

(c) An alternative method of compliance or adjustment of the compliance time that provides an equivalent level of safety may be approved by the Manager, Small Airplane Directorate, FAA, 1201 Walnut, suite 900,Kansas City, Missouri 64106. The request shall be forwarded through an appropriate FAA Maintenance Inspector, who may add comments and then send it to the Manager, Small Airplane Directorate.

NOTE 2: Information concerning the existence of approved alternative methods of compliance with this AD, if any, may be obtained from the Small Airplane Directorate.

(d) Questions or technical information related to DG Flugzeugbau Technical Note No. 826/32, dated July 19, 1996, and DG Flugzeugbau WORKING INSTRUCTION No. 1 for TN 826/32, dated July, 1996, should be directed to DG Flugzeugbau GmbH, P.O. Box 4120, 76625 Bruchsal, Germany; telephone: +49 7257-89-0; facsimile: +49 7257-8922. This service information may be examined at the FAA, Central Region, Office of the Regional Counsel, Room 1558, 601 E. 12th Street, Kansas City, Missouri 64106.

(e) The replacements required by this AD shall be done in accordance with DG Flugzeugbau Technical Note No. 826/32, dated July 19, 1996, and DG Flugzeugbau WORKING INSTRUCTION No. 1 for TN 826/32, dated July, 1996. This incorporation by reference was approved by the Director of the Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR part 51. Copies may be obtained from DG Flugzeugbau GmbH, P.O. Box 4120, 76625 Bruchsal, Germany. Copies may be inspected at the FAA, Central Region, Office of the Regional Counsel, Room 1558, 601 E. 12th Street, Kansas City, Missouri, or at the Office of the Federal Register, 800 North Capitol Street, NW, suite 700, Washington, DC.

NOTE 3: The subject of this AD is addressed in German AD 96-243 DG-Flugzeugbau, dated August 29, 1996.

(f) This amendment becomes effective on September 26, 1998.

Events Leading to the Issuance of This AD
A proposal to amend part 39 of the Federal Aviation Regulations (14 CFR part 39) to include an AD that would apply to all Glaser-Dirks Model DG-400 gliders was published in the Federal Register as a notice of proposed rulemaking (NPRM) on May 21, 1998 (63 FR 27870). The NPRM proposed to require replacing the propeller shaft, the bearings, and the front drive belt retaining rings with parts of improved design. Accomplishment of the proposed action as specified in the NPRM would be in accordance with DG Flugzeugbau Technical Note No. 826/32, dated July 19, 1996, and DG Flugzeugbau WORKING INSTRUCTION No. 1 for TN 826/32, dated July, 1996.

The NPRM was the result of mandatory continuing airworthiness information (MCAI) issued by the airworthiness authority for Germany.

Interested persons have been afforded an opportunity to participate in the making of this amendment. No comments were received on the proposed rule or the FAA's determination of the cost to the public.

The FAA's Determination
After careful review of all available information related to the subject presented above, the FAA has determined that air safety and the public interest require the adoption of the rule as proposed except for minor editorial corrections. The FAA has determined that these minor corrections will not change the meaning of the AD and will not add any additional burden upon the public than was already proposed.

Cost Impact
The FAA estimates that 35 gliders in the U.S. registry will be affected by this AD, that it will take approximately 5 workhours per glider to accomplish this action, and that the average labor rate is approximately $60 an hour. Parts cost approximately $460 per glider. Based on these figures, the total cost impact of this AD on U.S. operators is estimated to be $26,600, or $760 per glider.

Compliance Time of this AD
The compliance time of this AD is in calendar time instead of hours time-in-service (TIS). The average monthly usage of the affected glider ranges throughout the fleet. For example, one owner may operate the glider 25 hours TIS in one week, while another operator may operate the glider 25 hours TIS in one year. In order to ensure that all of the owners/operators of the affected glider have replaced the propeller shaft, bearings and front drive belt retaining rings within a reasonable amount of time, the FAA is utilizing a compliance time of 4 calendar months after the effective date of this AD.

Regulatory Impact
The regulations adopted herein will not have substantial direct effects on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government. Therefore, in accordance with Executive Order 12612, it is determined that this final rule does not have sufficient federalism implications to warrant the preparation of a Federalism Assessment.
For the reasons discussed above, I certify that this action (1) is not a "significant regulatory action" under Executive Order 12866; (2) is not a "significant rule" under DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and (3) will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act. A copy of the final evaluation prepared for this action is contained in the Rules Docket. A copy of it may be obtained by contacting the Rules Docket at the location provided under the caption "ADDRESSES".

List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety.

Adoption of the Amendment
Accordingly, pursuant to the authority delegated to me by the Administrator, the Federal Aviation Administration amends part 39 of the Federal Aviation Regulations (14 CFR part 39) as follows:

PART 39 - AIRWORTHINESS DIRECTIVES
1. The authority citation for part 39 continues to read as follows: Authority: 49 U.S.C. 106(g), 40113, 44701.

39.13 [Amended]
2. Section 39.13 is amended by adding a new airworthiness directive (AD) to read as follows:

Service information that applies to this AD may be obtained from Glaser-Dirks Flugzeugbau GmbH, Im Schollengarten 19-20, 7520 Bruchsal 4, Germany; telephone: +49 7257-89-0; facsimile: +49 7257-8922. This information may also be examined at the Federal Aviation Administration (FAA), Central Region, Office of the Regional Counsel, Attention: Rules Docket No. 98-CE-07-AD, Room 1558, 601 E. 12th Street, Kansas City, Missouri 64106; or at the
Office of the Federal Register, 800 North Capitol Street, NW, suite 700, Washington, DC.

Mike Kiesov, Aerospace Engineer, FAA, Small Airplane Directorate, Aircraft Certification Service, 1201 Walnut, suite 900, Kansas City, Missouri 64106; telephone: (816) 426-6934; facsimile: (816) 426-2169.