AD 95-18-04 ACTIVE

This amendment adopts a new airworthiness directive (AD), applicable to certain Beech Model 400 and 400A airplanes, that requires modification of the autopilot and rudder boost interlock. This amendment is prompted by a report indicating that the rudder boost system installed on these airplanes does not operate correctly during deployment of a thrust reverser. The actions specified by this AD are intended to prevent incorrect operation of the rudder boost system during deployment of a thrust reverser and to prevent the autopilot from exceeding certain bank angle limits; these conditions could result in reduced controllability of the airplane.

Final rule.

95-18-04 BEECH AIRCRAFT CORPORATION: Amendment 39-9352. Docket 95-NM-31-AD.

Applicability: Model 400 airplanes, serial RJ-61; and Model 400A airplanes, serials RK-1 through RK-77 inclusive, and RK-79 through RK-92 inclusive; certificated in any category.

NOTE 1: This AD applies to each airplane identified in the preceding applicability provision, regardless of whether it has been modified, altered, or repaired in the area subject to the requirements of this AD. For airplanes that have been modified, altered, or repaired so that the performance of the requirements of this AD is affected, the owner/operator must use the authority provided in paragraph (b) of this AD to request approval from the FAA. This approval may address either no action, if the current configuration eliminates the unsafe condition; or different actions necessary to address the unsafe condition described in this AD. Such a request should include an assessment of the effect of the changed configuration on the unsafe condition addressed by this AD. In no case does the presence of any modification, alteration, or repair remove any airplane from the applicability of this AD.

Compliance: Required as indicated, unless accomplished previously.

To prevent reduced controllability of the airplane, accomplish the following:

(a) At the next scheduled inspection, but no later than 200 hours time-in-service after the effective date of this AD, install an autopilot and rudder boost improvement kit in accordance with Beechcraft Service Bulletin No. 2533, dated October 1994.

(b) An alternative method of compliance or adjustment of the compliance time that provides an acceptable level of safety may be used if approved by the Manager, Wichita Aircraft Certification Office (ACO), FAA, Small Airplane Directorate. Operators shall submit their requests through an appropriate FAA Principal Maintenance Inspector, who may add comments and then send it to the Manager, Wichita ACO.NOTE 2: Information concerning the existence of approved alternative methods of compliance with this AD, if any, may be obtained from the Wichita ACO.

(c) Special flight permits may be issued in accordance with sections 21.197 and 21.199 of the Federal Aviation Regulations (14 CFR 21.197 and 21.199) to operate the airplane to a location where the requirements of this AD can be accomplished.

(d) The installation shall be done in accordance with Beechcraft Service Bulletin No. 2533, dated October 1994. This incorporation by reference was approved by the Director of the Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR part 51. Copies may be obtained from Beech Aircraft Corporation, Commercial Service Department, P.O. Box 85, Wichita, Kansas 67201-0085. Copies may be inspected at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington; or at the FAA, Wichita Aircraft Certification Office, Small Airplane Directorate, 1801 Airport Road, Room 100, Mid-Continent Airport, Wichita, Kansas; or at the Office of the Federal Register, 800 North Capitol Street, NW., suite 700, Washington, DC.

(e) This amendment becomes effective on October 10, 1995.

A proposal to amend part 39 of the Federal Aviation Regulations (14 CFR part 39) to include an airworthiness directive (AD) that is applicable to certain Beech Model 400 and 400A airplanes was published in the Federal Register on May 4, 1995 (60 FR 22013). That action proposed to require modification of the autopilot and rudder boost interlock.

Interested persons have been afforded an opportunity to participate in the making of this amendment. No comments were submitted in response to the proposal or the FAA's determination of the cost to the public. The FAA has determined that air safety and the public interest require the adoption of the rule as proposed.

There are approximately 92 Model 400 and 400A series airplanes of the affected design in the worldwide fleet. The FAA estimates that 69 airplanes of U.S. registry will be affected by this AD, that it will take approximately 24 work hours per airplane to accomplish the required actions, and that the average labor rate is $60 per work hour. Required parts will be provided by the manufacturer at no cost to operators. Based on these figures, the total cost impact of the AD on U.S. operators is estimated to be $99,360, or $1,440 per airplane.

The total cost impact figure discussed above is based on assumptions that no operator has yet accomplished any of the requirements of this AD action, and that no operator would accomplish those actions in the future if this AD were not adopted.

The regulations adopted herein will not have substantial direct effects on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government. Therefore, in accordance with Executive Order 12612, it is determined that this final rule does not have sufficient federalism implications to warrant the preparation of a Federalism Assessment.

For the reasons discussed above, I certifythat this action (1) is not a "significant regulatory action" under Executive Order 12866; (2) is not a "significant rule" under DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and (3) will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act. A final evaluation has been prepared for this action and it is contained in the Rules Docket. A copy of it may be obtained from the Rules Docket at the location provided under the caption "ADDRESSES."

List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety.

Adoption of the Amendment
Accordingly, pursuant to the authority delegated to me by the Administrator, the Federal Aviation Administration amends part 39 of the Federal Aviation Regulations (14 CFR part 39) as follows:

PART 39 - AIRWORTHINESS DIRECTIVES
1. The authority citation for part 39 continues to read as follows:
Authority: 49 USC 106(g), 40101, 40113, 44701.

39.13 - [Amended]
2. Section 39.13 is amended by adding the following new airworthiness directive:

The service information referenced in this AD may be obtained from Beech Aircraft Corporation, Commercial Service Department, P.O. Box 85, Wichita, Kansas 67201-0085. This information may be examined at the Federal Aviation Administration (FAA), Transport Airplane Directorate, Rules Docket, 1601 Lind Avenue, SW., Renton, Washington; or at the FAA, Wichita Aircraft Certification Office, Small Airplane Directorate, 1801 Airport Road, Room 100, Mid- Continent Airport, Wichita, Kansas; or at the Office of the Federal Register, 800 North Capitol Street, NW., suite 700, Washington, DC.

Dale Vassalli, Aerospace Engineer, Systems and Equipment Branch, ACE-130W, FAA, Wichita Aircraft Certification Office, Small Airplane Directorate, 1801 Airport Road, Room 100, Mid-Continent Airport, Wichita, Kansas 67209; telephone (316) 946-4132; fax (316) 946-4407.