| AD Number | 92-18-08 | Status | Active |
| Effective Date | October 02, 1992 | Issue Date | August 10, 1992 |
| Docket Number | 92-CE-07-AD | Amendment | 39-8352 |
| Product Type | ["Appliance"] | Product Subtype | Not specified |
| CFR Part | --- - Part 39 | CFR Section | --- - _EMPTY_ |
| Citation | This information is not available. | ||
| Manufacturer(s) | Piper Aircraft Inc. |
| Model(s) | PA-46-310P PA-46-350P |
92-18-08 BENDIX/KING: Amendment 39-8352. Docket No. 92-CE-07-AD.
Applicability: KAP 150/KFC 150 Flight Control Systems installed on Piper Models PA-46-310P and PA-46-350P airplanes, certificated in any category.
Compliance: Required within the next 90 calendar days after the effective date of this AD, unless already accomplished.
To prevent moisture from entering the electronic circuit board through the pitch servo, which could possibly lead to undesired movement of the elevator, accomplish the following:
(a) Install a pitch servo cover kit, part number 050-03007-0000, in accordance with the instructions in Bendix/King Installation Bulletin No. 312, dated March 19, 1990.
NOTE 1: Installation of the yaw servo cover kit, part number 050-03006-0000, which is referenced in Bendix/King Installation Bulletin No. 312, is not required by this AD action.
(b) Special flight permits may be issued in accordance with FAR 21.197 and 21.199 to operate airplanes to a location where the requirements of this AD can be accomplished.
(c) An alternative method of compliance or adjustment of the compliance time that provides an equivalent level of safety may be approved by the Manager, Wichita Aircraft Certification Office, 1801 Airport Road, Room 100, Mid-Continent Airport, Wichita, Kansas 67209. The request shall be forwarded through an appropriate FAA Maintenance Inspector, who may add comments and then send it to the Manager, Wichita Aircraft Certification Office.
NOTE 2: Information concerning the existence of approved alternative methods of compliance with this AD, if any, may be obtained from the Wichita Aircraft Certification Office.
(d) The installation required by this AD shall be done in accordance with Bendix/King Installation Bulletin No. 312, dated March 19, 1990. This incorporation by reference was approved by the Director of the Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR Part 51. Copies may be obtained from Bendix/King, Product Support Department, 400 N. Rogers Road, Olathe, Kansas 66062-0212. Copies may be inspected at the FAA, Central Region, Office of the Assistant Chief Counsel, Room 1558, 601 E. 12th Street, Kansas City, Missouri, or at the Office of the Federal Register, 800 North Capitol Street, NW, suite 700, Washington, DC.
(e) This amendment becomes effective on October 2, 1992.