| AD Number | 90-02-03 | Status | Active |
| Effective Date | February 09, 1990 | Issue Date | December 18, 1989 |
| Docket Number | 89-NM-178 | Amendment | 39-6438 |
| Product Type | ["Aircraft"] | Product Subtype | ["Large Airplane"] |
| CFR Part | --- - Part 39 | CFR Section | --- - _EMPTY_ |
| Citation | This information is not available. | ||
| Manufacturer(s) | Bombardier Inc. |
| Model(s) | DHC-8-101 DHC-8-102 DHC-8-103 DHC-8-106 DHC-8-201 DHC-8-202 DHC-8-301 DHC-8-311 DHC-8-315 DHC-8-400 DHC-8-401 DHC-8-402 |
90-02-03 BOEING OF CANADA, LTD., DE HAVILLAND DIVISION: Amendment 39-6438. Docket No. 89-NM-178-AD.
Applicability: Model DHC-8 series airplanes, Serial Numbers 1 through 119, certificated in any category.
Compliance: Required within 500 hours time-in-service or 90 days after the effective date of this AD, whichever occurs first, unless previously accomplished.
To prevent fatigue failure of the flap track No. 5 fail safe straps, accomplish the following:
A. Perform a visual inspection for cracks in the flap track No. 5 fail safe straps, in accordance with de Havilland Service Bulletin No. 8-57-10, dated March 31, 1989. If no cracks are found, modify strap holes in accordance with the service bulletin. If cracks are found, replace prior to further flight with a new fail safe strap, in accordance with the service bulletin.
B. An alternate means of compliance or adjustment of the compliance time, which provides an acceptable level of safety, may be used when approved by the Manager, New York Aircraft Certification Office, ANE-170, FAA, New England Region.
NOTE: The request should be forwarded through an FAA Principal Maintenance Inspector (PMI), who will either concur or comment and then send it to the Manager, New York Aircraft Certification Office, ANE-170.
C. Special flight permits may be issued in accordance with FAR 21.197 and 21.199 to operate airplanes to a base in order to comply with the requirements of this AD.
All persons affected by this directive who have not already received the appropriate service documents from the manufacturer may obtain copies upon request to Boeing of Canada, Ltd., de Havilland Division, Garratt Boulevard, Downsview, Ontario M3K 1Y5, Canada. These documents may be examined at the FAA, Northwest Mountain Region, Transport Airplane Directorate, 17900 Pacific Highway South, Seattle, Washington, or at the FAA, New England Region, New York Aircraft Certification Office, 181 South Franklin Avenue, Room 202, Valley Stream, New York.
This amendment (39-6438, AD 90-02-03) becomes effective on February 9, 1990.