| AD Number | 63-26-03 | Status | Active |
| Effective Date | July 13, 1971 | Issue Date | June 28, 1971 |
| Docket Number | Unknown | Amendment | 39-1240 |
| Product Type | ["Aircraft"] | Product Subtype | ["Small Airplane"] |
| CFR Part | --- - Part 39 | CFR Section | --- - _EMPTY_ |
| Citation | This information is not available. | ||
| Manufacturer(s) | Piper Aircraft Inc. |
| Model(s) | PA-23 PA-23-160 |
63-26-03 PIPER: Amdt. 663 Part 507 Federal Register December 24, 1963 as amended by Amendment 39-1240. Applies to Piper Models PA-23 and PA-23-160 Aircraft, Serial Numbers 23-1 through 23-1267, inclusive.
Compliance required as indicated:
(a) Within the next 50 hours in service after the effective date of this AD, unless already accomplished
within the last 50 hours in service, and thereafter at intervals not to exceed 100 hours in service from the last inspection, visually inspect for cracks each of the castings listed herein. When any casting is replaced by the respective forging listed herein, the repetitive inspections of this paragraph and paragraph (b) are no longer required for that forging.
NAME
CASTING
PART NO.
FORGING
Elevator Torque Tube Bracket
17033-00 and 17033-01
19407-00
Front Stabilizer Attachment
17049-00 and 19253-00
19409-02
Rudder Torque Tube Horn
17060-00
19405-00
Elevator Torque Tube Horn
17066-00
19404-00
RudderTorque Tube Bracket
17062-00
19408-00
Fin Attachment Bracket
17072-00
19406-00 or 19406-02
(b) For airplanes having 1,000 or more hours in service, remove the subject castings from the aircraft, clean thoroughly removing all paint, and perform a dye penetrant inspection for cracks, within the next 100 hours in service after the effective date of this AD, unless already accomplished within the last 400 hours in service, and thereafter at intervals not to exceed 500 hours in service from the last inspection. Prior to reinstallation of castings without cracks, clean thoroughly, and apply zinc chromate primer.
(c) Replace cracked castings before further flight with a replacement forged or cast part.
(d) Inspection and reassembly shall be accomplished in accordance with Piper Service Bulletin No. 155B, dated October 28, 1963, or FAA-approved equivalent.
NOTE: For paragraph (a), it is necessary to remove the tail cone, covers, and fairings to gain access to most of the parts to be inspected. However, parts need not be disassembled and/or removed from the aircraft to accomplish this inspection. All of the forged parts listed herein have integral raised digit forging numbers. Therefore, the absence of raised digits will serve to identify the part as a casting.
AD 63-26-03 Amendment 663 supersedes AD 57-13-09.
Amendment 663 was effective December 24, 1963.
Revised on April 26, 1966 and December 16, 1966.
This Amendment 39-1240 is effective July 13, 1971.