| AD Number | 86-06-07 | Status | Active |
| Effective Date | May 02, 1986 | Issue Date | Not specified |
| Docket Number | Unknown | Amendment | 39-5262 |
| Product Type | ["Aircraft"] | Product Subtype | ["Large Airplane"] |
| CFR Part | --- - Part 39 | CFR Section | N/A |
| Citation | This information is not available. | ||
| Manufacturer(s) | Short Brothers PLC |
| Model(s) | SD3-60 |
86-06-07 SHORT BROTHERS, LTD.: Amendment 39-5262. Applies to Short Brothers, Ltd., Model SD3-60 airplanes, serial numbers SH 3601 through SH 3665 inclusive, certificated in any category. Compliance is required within 90 days after the effective date of this AD, unless previously accomplished.
1. To prevent control system interference, install extended and additional guards in accordance with Short Brothers, Ltd., Service Bulletin SD360-27-04, dated March 1985.
2. Alternate means of compliance which provide an acceptable level of safety may be used when approved by the Manager, Standardization Branch, ANM-113, FAA, Northwest Mountain Region.
3. Special flight permits may be issued in accordance with FAR 21.197 and 21.199 to operate airplanes to a base for the accomplishment of inspections and/or modifications required by this AD.
All persons affected by this directive who have not already received the appropriate service document from the manufacturer may obtaincopies upon request to Shorts Aircraft, 1725 Jefferson Davis Highway, Suite 510, Arlington, Virginia 22202. This document may be examined at the FAA, Northwest Mountain Region, 17900 Pacific Highway South, Seattle, Washington, or the Seattle Aircraft Certification Office, 9010 East Marginal Way South, Seattle, Washington.
This amendment becomes effective May 2, 1986.