| AD Number | 77-23-05 | Status | Active |
| Effective Date | December 10, 1977 | Issue Date | Not specified |
| Docket Number | Unknown | Amendment | 39-3076 |
| Product Type | ["Aircraft"] | Product Subtype | ["Small Airplane"] |
| CFR Part | --- - Part 39 | CFR Section | N/A |
| Citation | This information is not available. | ||
| Manufacturer(s) | British Aerospace, Aircraft Group British Aerospace, Aircraft Group British Aerospace, Aircraft Group British Aerospace, Aircraft Group British Aerospace, Aircraft Group |
| Model(s) | B.206 Series 1 B.206 Series 2 |
77-23-05 SCOTTISH AVIATION, LTD. (Formerly BEAGLE AVIATION, LTD.): Amendment 39-3076. Applies to Beagle Model B206 Series 1 and Series 2 airplanes, certificated in all categories.
Compliance is required as indicated.
To prevent possible fatigue failure of the outer wing, wing center section, and empennage assemblies, accomplish the following:
(a) Prior to the accumulation of 11,000 hours total time in service on the outer wing, wing center section, or empennage assemblies, replace the affected assembly with an assembly of the same part number, or a part number approved by the Chief, Aircraft Certification Staff, FAA, Europe, Africa, and Middle East Region, which has accumulated less than 11,000 hours total time in service.
(b) Operators who have not kept records of hours of time in service on any assembly to which a provision of this AD applies shall substitute airplane hours time in service in lieu thereof.
(Scottish Aviation, Limited, Mandatory Service Bulletin No. B206/54, dated October 21, 1975, covers the same subject.)
This amendment becomes effective December 10, 1977.