| AD Number | 67-31-01 | Status | Active |
| Effective Date | December 11, 1967 | Issue Date | Not specified |
| Docket Number | Unknown | Amendment | 39-510 |
| Product Type | ["Aircraft"] | Product Subtype | ["Large Airplane"] |
| CFR Part | --- - Part 39 | CFR Section | N/A |
| Citation | This information is not available. | ||
| Manufacturer(s) | Airbus SAS |
| Model(s) | BAC 1-11 400 Series |
67-31-01 BRITISH AIRCRAFT: Amdt. 39-510, Part 39, Federal Register November 10, 1967. Applies to Model BAC 1-11 400 Series Airplanes.
Compliance required as indicated unless already accomplished.
To prevent the failure of the flap secondary transmission shaft, Hobson P/N CHA561- 067, located between the Number 1 and Number 2 screw jacks, accomplish the following:
(a) Within the next 350 landings after the effective date of this AD or before the accumulation of 1,500 landings, whichever occurs later, visually insect the flap secondary transmission shafts, Hobson P/N CHA 561-067, located between the Number 1 and Number 2 screw jack positions, for failure or signs of frettage deposit around each end and fitting and each fairlead sleeve, in accordance with British Aircraft Corporation BAC 1-11 Alert Service Bulletin No. 27-A-PM 3034, Issue 1, dated June 5, 1967, or later ARB-approved issue or an equivalent approved by the Chief, Aircraft Certification Staff, FAA, Europe, Africa and Middle East Region.
(b) If a frettage deposit is detected during the inspection required by paragraph (a), repeat the inspection required by paragraph (a) at intervals not to exceed 70 landings from the last inspection.
(c) If a frettage deposit is not detected during the inspection required by paragraph (a), repeat the inspection required by paragraph (a) at intervals not to exceed 350 landings from the last inspection.
(d) Replace failure flap secondary transmission shafts, Hobson P/N CHA 561-067, before further flight with a new shaft of the same part number or with a shaft repaired in accordance with BAC 1-11 Alert Service Bulletin No. 27-A-PM 3034, Issue 1, dated June 5, 1967, or later ARB-approved issue, or an equivalent repair approved by the Chief, Aircraft Certification Staff, FAA, Europe, Africa and Middle East Region. Continue the inspections required by paragraphs (a), (b) and (c) for the replacement or repaired shafts.
(e) The inspections requiredby paragraphs (a), (b), and (c) may be discontinued when the airplanes are modified in accordance with BAC 1-11 Service Bulletin 27 PM 3034, Part (a), or later ARB-approved issue, or an equivalent approved by the Chief, Aircraft Certification Staff, FAA, Europe, Africa and Middle East Region.
(f) For the purpose of complying with this AD, subject to acceptance by the assigned FAA maintenance inspector, the number of landings may be determined by dividing each airplane's hours time in service by the operator's fleet average time from takeoff to landing for the airplane type.
This amendment effective December 11, 1967.