| AD Number | 73-12-01 | Status | Active |
| Effective Date | July 01, 1973 | Issue Date | Not specified |
| Docket Number | Unknown | Amendment | 39-1650 |
| Product Type | ["Aircraft"] | Product Subtype | ["Rotorcraft"] |
| CFR Part | --- - Part 39 | CFR Section | N/A |
| Citation | This information is not available. | ||
| Manufacturer(s) | Bell Helicopter Textron Canada Limited |
| Model(s) | 206A 206A-1 (OH-58A) 206B 206B-1 |
73-12-01 BELL: Amendment 39-1650. Applies to Model 206A and 206B helicopters, serial numbers 4 through 865 and 867 through 873, certificated in all categories, equipped with vertical fin, P/N 206-020-113-5, -7 and -9.
Compliance required within the next 25 hours' time in service after the effective date of this A.D., unless already accomplished within the last 25 hours' time in service, and thereafter at intervals not to exceed 25 hours' time in service from the last inspection.
To detect possible fatigue cracks in the skin of the vertical fin in the area of the tail boom attachment, accomplish the following:
(a) Remove all tail fairing assemblies to gain access to the inboard side of the vertical fin assembly.
(b) Visually inspect the inboard skin of the vertical fin in the area of attachment for any cracks, paying particular attention to the area aft of the upper rear attachment insert.
(c) If any crack is found greater than 3.5 inches in length, removeand replace the fin before further flight.
(d) If any crack is found less than 3.5 inches in length, remove and replace or repair the fin in accordance with Part II of Bell Helicopter Company Service Letter No. 206-203, Revision C, dated March 14, 1973, or later FAA approved revision, before further flight.
(e) If no cracks are found, continue the repetitive inspections specified above.
(f) This A.D. is no longer applicable when the fin is modified in accordance with Part I or II of Bell Helicopter Company Service Letter No. 206-203, Revision C, dated March 14, 1973, or later FAA approved revision.
(Bell Helicopter Company Service Bulletin No. 206-01-73-1, dated January 9, 1973, pertains to this subject.)
This amendment becomes effective July 1, 1973.