AD 98-09-20 SUPERSEDED

This amendment adopts a new airworthiness directive (AD), applicable to certain Airbus Model A310 series airplanes, that requires repetitive inspections of the fuselage skin to detect corrosion or fatigue cracking around and under the chafing plates of the wing root; and corrective actions, if necessary. This amendment is prompted by issuance of mandatory continuing airworthiness information by a foreign civil airworthiness authority. The actions specified by this AD are intended to detect and correct fatigue cracks and corrosion around and under chafing plates of the wing root, which could result in reduced structural integrity of the airplane.

Final rule.

98-09-20 AIRBUS INDUSTRIE: Amendment 39-10501. Docket 96-NM-248-AD.

Applicability: Model A310 series airplanes on which Airbus Modifications 8888 and 8889 have not been accomplished; certificated in any category.

NOTE 1: This AD applies to each airplane identified in the preceding applicability provision, regardless of whether it has been otherwise modified, altered, or repaired in the area subject to the requirements of this AD. For airplanes that have been modified, altered, or repaired so that the performance of the requirements of this AD is affected, the owner/operator must request approval for an alternative method of compliance in accordance with paragraph (d) of this AD. The request should include an assessment of the effect of the modification, alteration, or repair on the unsafe condition addressed by this AD; and, if the unsafe condition has not been eliminated, the request should include specific proposed actions to address it.

Compliance: Required asindicated, unless accomplished previously.

To detect and correct fatigue cracking and corrosion around and under chafing plates of the wing root between fuselage frame (FR) 36 and FR 39, which could result in reduced structural integrity of the airplane, accomplish the following:

(a) Except as provided by paragraph (b) of this AD: Within 4 years since date of manufacture, or within 12 months after the effective date of this AD, whichever occurs later, perform an inspection to detect discrepancies around and under the chafing plates of the wing root, in accordance with paragraph B. of the Accomplishment Instructions of Airbus Service Bulletin A310-53-2069, Revision 1, dated September 19, 1995. If any discrepancy is found, prior to further flight, accomplish follow-on corrective actions (i.e., removal of corrosion, corrosion protection, high frequency eddy current inspection, x-ray inspection), as applicable, in accordance with the service bulletin. Repeat the inspections, asapplicable, thereafter, at intervals specified in the service bulletin.

(b) If any discrepancy is found as a result of an inspection required by paragraph (a) of this AD, and Airbus Service Bulletin A310-53-2069, Revision 1, dated September 19, 1995, specifies to contact Airbus for an appropriate action: Prior to further flight, repair in accordance with a method approved by the Manager, International Branch, ANM-116, FAA, Transport Airplane Directorate. Where differences in the compliance times or corrective actions exist between the service bulletin and this AD, the AD prevails.

(c) Accomplishment of the replacement of the chafing plates in accordance with Airbus Service Bulletin A310-53-2070, dated October 3, 1994, constitutes terminating action for the repetitive inspection requirement of this AD.

(d) An alternative method of compliance or adjustment of the compliance time that provides an acceptable level of safety may be used if approved by the Manager, International Branch, ANM-116. Operators shall submit their requests through an appropriate FAA Principal Maintenance Inspector, who may add comments and then send it to the Manager, International Branch, ANM-116.

NOTE 2: Information concerning the existence of approved alternative methods of compliance with this AD, if any, may be obtained from the International Branch, ANM-116.

(e) Special flight permits may be issued in accordance with sections 21.197 and 21.199 of the Federal Aviation Regulations (14 CFR 21.197 and 21.199) to operate the airplane to a location where the requirements of this AD can be accomplished.

(f) The actions shall be done in accordance with Airbus Service Bulletin A310-53-2069, Revision 1, dated September 19, 1995 and Airbus Service Bulletin A310-53-2070, dated October 3, 1994. This incorporation by reference was approved by the Director of the Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR part 51. Copies may be obtained from Airbus Industrie, 1 Rond Point Maurice Bellonte, 31707 Blagnac Cedex, France. Copies may be inspected at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington; or at the Office of the Federal Register, 800 North Capitol Street, NW., suite 700, Washington, DC.

NOTE 3: The subject of this AD is addressed in French airworthiness directive 96-008- 175(B), dated January 3, 1996.

(g) This amendment becomes effective on June 3, 1998.

A proposal to amend part 39 of the Federal Aviation Regulations (14 CFR part 39) to include an airworthiness directive (AD) that is applicable to certain Airbus Model A310 series airplanes was published in the Federal Register on February 24, 1998 (63 FR 9163). That action proposed to require repetitive inspections of the fuselage skin to detect corrosion or fatigue cracking around and under the chafing plates of the wing root; and corrective actions, if necessary.

Comments
Interested persons have been afforded an opportunity to participate in the making of this amendment. No comments were submitted in response to the proposal or the FAA's determination of the cost to the public.

Conclusion
The FAA has determined that air safety and the public interest require the adoption of the rule as proposed.

Cost Impact
The FAA estimates that 36 airplanes of U.S. registry will be affected by this AD, that it will take approximately 68 work hours per airplane to accomplish the required inspection, and that the average labor rate is $60 per work hour. Based on these figures, the cost impact of the AD on U.S. operators is estimated to be $146,880, or $4,080 per airplane, per inspection cycle.

Should an operator elect to accomplish the optional terminating action rather than continue the repetitive inspections, it will take approximately 45 work hours per airplane to accomplish the modification, at an average labor rate of $60 per work hour. Required parts will cost approximately $2,229 per airplane. Based on these figures, the cost impact of this optional terminating action is estimated to be $4,929 per airplane.

The cost impact figures discussed above are based on assumptions that no operator has yet accomplished any of the requirements of this AD action, and that no operator would accomplish those actions in the future if this AD were not adopted.

Regulatory Impact
The regulations adopted herein will not have substantialdirect effects on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government. Therefore, in accordance with Executive Order 12612, it is determined that this final rule does not have sufficient federalism implications to warrant the preparation of a Federalism Assessment.

For the reasons discussed above, I certify that this action (1) is not a "significant regulatory action" under Executive Order 12866; (2) is not a "significant rule" under DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and (3) will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act. A final evaluation has been prepared for this action and it is contained in the Rules Docket. A copy of it may be obtained from the Rules Docket at the location provided under the caption "ADDRESSES."

List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety.

Adoption of the Amendment
Accordingly, pursuant to the authority delegated to me by the Administrator, the Federal Aviation Administration amends part 39 of the Federal Aviation Regulations (14 CFR part 39) as follows:
PART 39 - AIRWORTHINESS DIRECTIVES
1. The authority citation for part 39 continues to read as follows:
Authority: 49 U.S.C. 106(g), 40113, 44701.
39.13 [Amended]
2. Section 39.13 is amended by adding the following new airworthiness directive:

The service information referenced in this AD may be obtained from Airbus Industrie, 1 Rond Point Maurice Bellonte, 31707 Blagnac Cedex, France. This information may be examined at the Federal Aviation Administration (FAA), Transport Airplane Directorate, Rules Docket, 1601 Lind Avenue, SW., Renton, Washington; or at the Office of the Federal Register, 800 North Capitol Street, NW., suite 700, Washington, DC.

FOR FURTHER INFORMATION CONTACT: Norman B. Martenson, Manager, International Branch, ANM-116, FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington 98055-4056; telephone (425) 227-2110; fax (425) 227-1149.