| AD Number | 78-20-08 | Status | Active |
| Effective Date | October 12, 1978 | Issue Date | Not specified |
| Docket Number | Unknown | Amendment | 39-3311 |
| Product Type | ["Aircraft"] | Product Subtype | ["Small Airplane"] |
| CFR Part | --- - Part 39 | CFR Section | N/A |
| Citation | This information is not available. | ||
| Manufacturer(s) | Textron Aviation Inc. |
| Model(s) | 76 |
78-20-08 BEECH: Amendment 39-3311. Applies to Model 76 (Serial Numbers ME-1 through ME-62 and ME-66) airplanes.
To preclude failure of the rudder and elevator trim tab push rods, prior to further flight:
A) If not previously accomplished, replace Beech Part Number 105-520024-5 rudder trim tab push rod with new Beech Part Number 105-520045-9 rudder trim tab push rod and rebalance the rudder control surface, where necessary, in accordance with Beechcraft Liberal Service Letter No. 78-4 dated September 14, 1978, or later approved revisions.
B) If not previously accomplished, replace Beech Part Number 105-520024-1 elevator trim tab push rod with new Beech Part Number 105-520048-1 elevator trim tab push rod and rebalance the elevator control surfaces, where necessary, in accordance with Beechcraft Liberal Service Letter No. 78-4 dated September 14, 1978, or later approved revisions.
C) Aircraft may not be flown in accordance with FAR 21.197 to a base to accomplish this AD, unless authorized by the Chief, Engineering and Manufacturing Branch, FAA, Central Region.
D) Any equivalent method of compliance with this AD must be approved by the Chief, Engineering and Manufacturing Branch, FAA, Central Region.
This amendment becomes effective October 12, 1978, to all persons except those to whom it has already been made effective by telegram from the FAA dated September 9, 1978.