| AD Number | 72-19-01 | Status | Active |
| Effective Date | September 15, 1972 | Issue Date | Not specified |
| Docket Number | Unknown | Amendment | 39-1517 |
| Product Type | ["Aircraft"] | Product Subtype | ["Rotorcraft"] |
| CFR Part | --- - Part 39 | CFR Section | N/A |
| Citation | This information is not available. | ||
| Manufacturer(s) | Bell Helicopter Textron Canada Limited |
| Model(s) | 206A 206A-1 (OH-58A) 206B 206B-1 |
72-19-01 BELL: Amdt. 39-1517. Applies to Bell Models 206A, 206B, 206A-1 and 206B-1 helicopters certificated in all categories.
Compliance required as indicated.
To prevent possible failure of the main rotor retention strap fitting, P/N 206-010-155-7, and the main rotor retention strap pin, P/N 206-010-123-1, accomplish the following:
(a) Remove and replace retention strap fittings, P/N 206-010-155-7, with 90 or more hours total time in service on the effective date of this A.D., within the next 10 hours time in service.
(b) Remove and replace retention strap fittings, P/N 206-010-155-7, with less than 90 hours total time in service on the effective date of this A.D. prior to accumulating 100 hours time in service.
(c) Remove and replace retention strap pins, P/N 206-010-123-1, with 90 or more hours total time in service on the effective date of this A.D. within the next 10 hours time in service.
(d) Remove and replace retention strap pins, P/N 206-010-123-1, with less than 90 hours total time in service on the effective date of this A.D., prior to accumulating 100 hours time in service.
(e) The requirements of paragraphs (a) and (b) are not applicable to main rotor retention strap fittings, P/N 206-010-155-11 or -15.
The requirements of paragraphs (c) and (d) are not applicable to main rotor retention strap pins, P/N 206-010-123-3.
This supersedes Amendment 39-1510 (37 F.R. 17544), A.D. 72-18-05, which superseded 72-17-04.
This amendment becomes effective September 15, 1972.