| AD Number | 49-28-01 | Status | Active |
| Effective Date | Not specified | Issue Date | Not specified |
| Docket Number | Unknown | Amendment | N/A |
| Product Type | ["Aircraft"] | Product Subtype | ["Small Airplane"] |
| CFR Part | --- - Part 39 | CFR Section | N/A |
| Citation | This information is not available. | ||
| Manufacturer(s) | Sierra Hotel Aero, Inc. |
| Model(s) | Navion (Army L-17A) Navion A (Army L-17B and L-17C) |
49-28-01 NAVION: Applies to All Airplanes Equipped With Product Techniques, Inc., Propeller Spinners.
To be accomplished as specified below:
In order to preclude the possibility of continued use of any unsatisfactory spinners which may be in existence, the following steps must be taken:
1. Spinners not previously installed on an aircraft must be inspected before installation for the thickness of the bulkhead. This may be accomplished by measuring the thickness of the bulkhead at the perimeter; measurements should be taken about 1/2 inch from the edge for best accuracy. The manufacturing process used in fabricating the bulkheads reduces the gage of the material about 0.012 inch at the perimeter. Bulkheads measuring less than 0.045 inch at this point must be replaced with heavier gage steel bulkheads.
2. Spinners which have partially completed the inspections previously required by AD 49-01-01 may continue in service until the next 10-hour inspection at which time thebulkhead should be gaged as specified above and replace if under 0.045-inch thickness.
3. Spinners having satisfactorily passed the five inspection periods required by AD 49-01-01 must be inspected for bulkhead thickness, as specified above, within the next 50 hours of flight, and replaced if under 0.045-inch thickness.
It has been determined that bulkheads of 0.058-inch and 0.064-inch cadmium plated steel are satisfactory and do not require the periodic inspections previously specified in AD 49-01-01. However, bulkheads made of thinner gage steel, or of aluminum, are unsatisfactory.
This supersedes AD 49-01-01.