| AD Number | 73-11-08 | Status | Active |
| Effective Date | June 22, 1973 | Issue Date | Not specified |
| Docket Number | Unknown | Amendment | 39-1648 |
| Product Type | ["Aircraft"] | Product Subtype | ["Small Airplane"] |
| CFR Part | --- - Part 39 | CFR Section | N/A |
| Citation | This information is not available. | ||
| Manufacturer(s) | Aermacchi S.p.A. |
| Model(s) | S.205 - 18/F S.205 - 18/R S.205 - 20/F S.205 - 20/R S.205 - 22/R |
73-11-08 SIAI-MARCHETTI: Amdt. 39-1648. Applies to SIAI Marchetti Model S.205 airplanes, Serial Numbers 001, 002, 003, 101 through 399, and 4-101 through 4-212.
Compliance is required within the next 100 hours' time in service after the effective date of this AD unless already accomplished.
To provide a means for periodic lubrication of the main and nose landing gear torque link pins and bolts accomplish the following in accordance with SIAI Marchetti Service Bulletin No. SB 205B35 dated March 13, 1972, or an FAA-approved equivalent:
(a) Remove the existing main and nose landing gear center torque link hinge bolts and main and nose landing gear upper and lower torque link to landing gear pins.
(b) Clean the bushings by removing rust residue; install the following bolts, pins, and grease fittings in the locations indicated, and check the fit between the pins and bushings.
(1) Install new pins with grease fittings, P/N 205-9-043-01, in the upper and lower main gear torque link to main gear leg connections with the grease fittings pointing toward the airplane centerline.
(2) Install new bolts with grease fittings, P/N 205-9-063-01, in the main landing gear upper to lower torque link connections.
(3) Install new pins, P/N 205-9-137-11 and P/N 205-9-138-11, in the upper and lower torque link to nose landing gear leg connections, respectively, and install grease fittings, P/N 205-9-154-01.
(4) Install a new bolt with grease fitting, P/N 205-9-153-01, in the nose landing gear upper to lower torque link connection.
This amendment becomes effective June 22, 1973.