Back to AD

AD 50-01-01 ACTIVE

Engine Mount Reinforcement
Key Information
AD Number 50-01-01 Status Active
Effective Date Not specified Issue Date Not specified
Docket Number Unknown Amendment N/A
Product Type ["Aircraft"] Product Subtype ["Small Airplane"]
CFR Part --- - Part 39 CFR Section N/A
Citation This information is not available.
Applicability
Manufacturer(s) Mooney Mite Aircraft Corporation
Model(s) M-18L
Regulatory Text

50-01-01 MOONEY: Applies to All Model M-18L Aircraft.
Compliance required as soon as possible but not later than next 25 hours operating time and at each 25-hour period thereafter until reinforcement of engine mount lugs is accomplished.
Inspect the four engine mount lugs for cracks. If cracks are evident, reweld the lugs to mate with the mount holes on the engine and weld an X-4130 0.058-inch strap 1/2 x 3-inches to the lug and the side tube member. Further inspections are not necessary after the above reinforcement of the lugs is made.
(Mooney Service Bulletin No. 4 covers this same subject.)