| AD Number | 73-18-01 | Status | Active |
| Effective Date | August 27, 1973 | Issue Date | Not specified |
| Docket Number | Unknown | Amendment | 39-1705 |
| Product Type | ["Aircraft"] | Product Subtype | ["Large Airplane"] |
| CFR Part | --- - Part 39 | CFR Section | N/A |
| Citation | This information is not available. | ||
| Manufacturer(s) | Kelowna Flightcraft R & D Ltd. |
| Model(s) | 340 440 Military C-131E |
73-18-01 GENERAL DYNAMICS: Amdt. 39-1705. Applies to General Dynamics 340/440/580/640 (Convair) Series and Model C-131E airplanes certificated in all categories.
Compliance required as indicated.
To prevent possible collapse of the nose landing gear due to fatigue cracks in the drag strut upper left hand segments, accomplish the following.
(a) Within ten landings after the effective date of this A.D., unless already accomplished with the last 590 landings prior to this A.D., and at one additional interval not to exceed 600 landings thereafter, preform an external visual inspection of all P/N 340-5210103, 340-5215103 or 340-7310231 nose landing gear drag strut upper left hand segments for crack development in the area depicted by Figure 1, View A-A, General Dynamics Service Bulletin 640(340D) No. 32-7, dated June 20, 1973, by dye penetrant, eddy current or ultrasonic methods, per the accomplishment instructions in S.B. 32-7, dated June 20, 1973, or later FAA-approvedrevisions. (Disassembly of strut is not required).
(1) If crack development is noted, replace the drag strut prior to further flight, with new P/N 340-7310231-1, or serviceable parts (Items 1 through 4, Convair Service Engineering Report No. 340-44A/440-44A, dated June 16, 1961).
(2) If crack development is not indicated after the accomplishment of the foregoing inspections, repeat the inspection thereafter at intervals not to exceed 2,400 landings. If cracks are discovered, replace the drag strut, prior to further flight per a(1) above.
(3) If new P/N 340-7310231-1 is used as a replacement, the inspections of this A.D. may be discontinued, and normal maintenance practices will be observed.
(4) If a re-worked part (cf: Convair Service Engineering Report, No. 340- 44A/440-44A) is used as a replacement, perform an inspection for crack development prior to an additional 600 landings after installation per a, above. Repeat the inspections per a and (2) above.(5) Any parts removed for crack development per this A.D., or as a result of any other inspection indicating a like condition, may not be returned to service unless a specific rework procedure has been approved by the Chief, Aircraft Engineering Division, FAA Western Region, and accomplished as to said parts.
(6) Aircraft may be operated per FAR 21.197 to a base for accomplishment of maintenance per this A.D.
(b) Equivalent inspections and installations may be approved by the Chief, Aircraft Engineering Division, FAA Western Region.
(c) For the purpose of complying with this A.D., subject to acceptance by the assigned FAA maintenance inspector, the number of landings may be determined by dividing each airplane's hours' time in service by the operator's fleet average time from takeoff to landing for the airplane type.
This amendment is effective August 27, 1973 except those to whom it was made effective immediately by airmail letter, dated July 30, 1973.