| AD Number | 60-09-02 | Status | Active |
| Effective Date | Not specified | Issue Date | Not specified |
| Docket Number | Unknown | Amendment | N/A |
| Product Type | ["Aircraft"] | Product Subtype | ["Small Airplane"] |
| CFR Part | --- - Part 39 | CFR Section | N/A |
| Citation | This information is not available. | ||
| Manufacturer(s) | Univair Aircraft Corporation |
| Model(s) | 415-C 415-CD 415-D F-1 |
60-09-02 FORNEY: Amdt. 137 Part 507 Federal Register April 30, 1960. Applies to Models Erco 415 Series and Aircoupe F-1 Aircraft Serial Numbers 1 Through 5678 Incorporating Electrol Hose Gear With Aluminum Scissors.
Compliance required not later than July 1, 1960.
Bolts used to attach the forged aluminum scissors to the electrol nose gear were found to be brittle. To preclude failure of these bolts and the danger of the nose wheel turning crosswise during landing, the following shall be accomplished:
Replace bolts, P/N 415-34330, with AN 5-26 bolts, AN 960 washers (two per bolt) and AN 310-5 nuts. The tightened nut must not cause binding.
(Forney Service Bulletin No. 103 covers this same subject.)