Back to AD

AD 78-13-02 ACTIVE

Weather Radar Receiver/Transmitter
Key Information
AD Number 78-13-02 Status Active
Effective Date July 05, 1978 Issue Date Not specified
Docket Number Unknown Amendment 39-3245
Product Type ["Aircraft"] Product Subtype ["Large Airplane"]
CFR Part --- - Part 39 CFR Section N/A
Citation This information is not available.
Applicability
Manufacturer(s) Textron Aviation Inc.
Model(s) BH.125 Series 600A HS.125 Series 600A HS.125 Series 700A
Regulatory Text

78-13-02 BRITISH AEROSPACE: Amendment 39-3245. Applies to Hawker Siddeley Model BH/HS-125 Series 600A and 700A airplanes, certificated in all categories, that have either the RCA AVQ21 or Primus 40 weather radar systems installed.

Compliance required as indicated.

To prevent failure of the restraint provisions for the weather radar receiver/transmitter, accomplish the following:

(a) Within 10 hours time in service after the effective date of this AD, unless already accomplished within the last 40 hours time in service, and thereafter at intervals not to exceed 50 hours time in service from the last inspection, inspect the support brackets for cracks and the "T" bolts for failure of the brazing in accordance with section 2, "Accomplishment Instructions" of British Aerospace Alert Service Bulletin 34-A134, dated April 1, 1978, or an FAA approved equivalent.

(b) If a crack in a support bracket or a failure of the brazing of the "T" bolt is found during an inspection required by paragraph (a) of this AD, before further flight, except that the airplane may be flown in accordance with FAR 21.197 and 21.199 to a base where the replacement can be accomplished, replace the mounting tray with a serviceable part of the same part number, or repair the existing mounting tray in accordance with an FAA approved repair scheme and continue to inspect in accordance with paragraph (a) of this AD, or replace the mounting tray in accordance with paragraph (c) of this AD.

(c) The inspections required by this AD may be discontinued upon replacement of the mounting tray with an improved standard tray, P/N 1719353-501 (Rev. E), in accordance with British Aerospace Modification 258171 or an FAA approved equivalent.

This amendment becomes effective July 5, 1978.