| AD Number | 76-07-13 | Status | Active |
| Effective Date | April 26, 1976 | Issue Date | Not specified |
| Docket Number | Unknown | Amendment | 39-2579 |
| Product Type | ["Aircraft"] | Product Subtype | ["Large Airplane"] |
| CFR Part | --- - Part 39 | CFR Section | N/A |
| Citation | This information is not available. | ||
| Manufacturer(s) | Hamburger Flugzeugbau G.m.b.H. |
| Model(s) | HFB 320 Hansa |
76-07-13 HAMBURGER FLUGZEUGBAU GmbH: Amendment 39-2579. Applies to Model HFB-320 airplanes, S/N 1021 thru 1023, 1026 thru 1028, 1030 thru 1040, 1045, and 1049 thru 1057, certificated in all categories.
Compliance is required within the next 25 hours time in service after the effective date of this AD, unless already accomplished.
To detect possible incorrect adjustment of camlocks that could result in cracking of the camlock housing, possible inadvertent opening of the door, and inflight explosive decompression, accomplish the following:
(a) Inspect the camlocks for correct adjustment in accordance with the accomplishment instructions contained in Section B, Part 1, of HFB Hansa Alert Service Bulletin 53-21A, dated October 13, 1975, as revised January 20, 1976, or an FAA-approved equivalent.
(b) If a camlock is found out of adjustment beyond the tolerances specified in HFB Hansa Alert Service Bulletin 53-21A, dated October 13, 1975, as revised January 20, 1976,or an FAA-approved equivalent, rectify the camlock adjustment in accordance with the accomplishment instructions contained in Section B, Part 2, of Service Bulletin 53-21A, dated October 13, 1975, as revised January 20, 1976, or an FAA-approved equivalent.
(c) Inspect the door frame camlock housings, which house the camlocks for which adjustment is required in accordance with paragraph (b) of this AD, for cracks, using a dye penetrant method in accordance with the instructions contained in Section B, Part 3, of HFB Hansa Alert Service Bulletin 53-21A, dated October 13, 1975, as revised January 20, 1976, or an FAA-approved equivalent.
(d) If any cracks are found in the door frame camlock housing during the inspection required by paragraph (c) of this AD, before further flight, except that the aircraft may be flown unpressurized in accordance with FAR's 21.197 and 21.199 to a base where the replacement can be accomplished, replace the camlock housing with a new part of the samepart number.
This amendment becomes effective, April 26, 1976.