| AD Number | 93-15-05 | Status | Active |
| Effective Date | August 18, 1993 | Issue Date | Not specified |
| Docket Number | 93-NM-117-AD | Amendment | 39-8651 |
| Product Type | ["Aircraft"] | Product Subtype | ["Large Airplane"] |
| CFR Part | --- - Part 39 | CFR Section | N/A |
| Citation | This information is not available. | ||
| Manufacturer(s) | Airbus SAS |
| Model(s) | A320-111 A320-211 A320-212 A320-214 A320-231 A320-232 A320-233 |
93-15-05 AIRBUS INDUSTRIE: Amendment 39-8651. Docket 93-NM-117-AD.
Applicability: Model A320 series airplanes on which Airbus Industrie Modification 20856 or Airbus Industrie Service Bulletin A320-32-1090 has been accomplished, and on which Airbus Industrie Modification 23597 or Airbus Industrie Service Bulletin A320-32-1114 has not been accomplished; certificated in any category.
Compliance: Required as indicated, unless accomplished previously.
To prevent reduced braking performance, accomplish the following:
(a) Within 30 days after the effective date of this AD, revise the Limitations Section of the FAA-approved Airplane Flight Manual (AFM) by inserting a copy of Airbus Industrie A320 Flight Manual Temporary Revision 9.99.99/89, Issue 2, dated December 16, 1992, in the AFM.
(b) Accomplishment of Airbus Industrie Modification 23597 or Airbus Industrie Service Bulletin A320-32-1114 and replacement of Airbus Industrie A320 Flight Manual Temporary Revision 9.99.99/89, Issue 2, dated December 16, 1992, with Airbus Industrie A320 Flight Manual Temporary Revision 9.99.99/89, Issue 3, dated February 8, 1993, in the AFM constitutes terminating action for the requirements of paragraph (a) of this AD.
(c) An alternative method of compliance or adjustment of the compliance time that provides an acceptable level of safety may be used if approved by the Manager, Standardization Branch, ANM-113, FAA, Transport Airplane Directorate. Operators shall submit their requests through an appropriate FAA Principal Maintenance Inspector, who may add comments and then send it to the Manager, Standardization Branch, ANM-113.
NOTE: Information concerning the existence of approved alternative methods of compliance with this AD, if any, may be obtained from the Standardization Branch, ANM-113.
(d) Special flight permits may be issued in accordance with FAR 21.197 and 21.199 to operate the airplane to a location where the requirements of this AD can be accomplished.
(e) The AFM revision shall be accomplished in accordance with Airbus Industrie A320 Flight Manual Temporary Revision 9.99.99/89, Issue 2, dated December 16, 1992, which contains the following list of effective pages:
Page Number
Issue Level
Shown on Page
Date
Shown on Page
1
2
December 16, 1992
2
Original
November 3, 1992
This incorporation by reference was approved by the Director of the Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR Part 51. Copies may be obtained from Airbus Industrie, 1 Rond Point Maurice Bellonte, 31707 Blagnac Cedex, France. Copies may be inspected at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington; or at the Office of the Federal Register, 800 North Capitol Street, NW., suite 700, Washington, DC.
(f) This amendment becomes effective on August 18, 1993.