| AD Number | 47-30-02 | Status | Active |
| Effective Date | Not specified | Issue Date | Not specified |
| Docket Number | Unknown | Amendment | N/A |
| Product Type | ["Aircraft"] | Product Subtype | ["Small Airplane"] |
| CFR Part | --- - Part 39 | CFR Section | N/A |
| Citation | This information is not available. | ||
| Manufacturer(s) | Cessna Aircraft Company |
| Model(s) | T-50 |
47-30-02 CESSNA: (Was Mandatory Note 12 of AD-722-5.) Applies to T-50 Aircraft.
Compliance required no later than next 100 hour inspection.
Inspect the ends of the brake pedal links, P/N 53046, for reinforcing doubler plates around the fitting holes. If the doubler is not in evidence, remove the links and rivet two 0.040 inch x 1/2-inch x approximately 2-inch length - 24ST aluminum alloy reinforcing doubler plates to each end of each link using two 1/8-inch A17ST rivets through both doublers and the link on the far side of the joggle from the fitting holes.