| AD Number | 79-23-06 | Status | Active |
| Effective Date | November 23, 1979 | Issue Date | Not specified |
| Docket Number | Unknown | Amendment | 39-3615 |
| Product Type | ["Aircraft"] | Product Subtype | ["Small Airplane"] |
| CFR Part | --- - Part 39 | CFR Section | N/A |
| Citation | This information is not available. | ||
| Manufacturer(s) | Textron Aviation Inc. |
| Model(s) | 76 |
79-23-06 BEECH: Amendment 39-3615. Applies to Model 76 (Serial Numbers ME-1 through ME-164, ME-166, ME-168 through ME-181, ME-184 through ME-193, ME-195 and ME-198) airplanes certificated in all categories.
COMPLIANCE: Required as indicated unless already accomplished.
To prevent possible restriction in aileron and rudder travel, within twenty-five (25) hours time-in-service after the effective date of this AD accomplish the following:
A) On Serial Numbers ME-1 through ME-149, ME-151 through ME-164, ME-166, ME-168 through ME-181, ME-184 through ME-190, ME-192, and ME-193 visually inspect and, if necessary, replace the stop bolt nuts for the aileron bell cranks with self-locking nuts in accordance with procedures set forth in Beechcraft Service Instructions Number 1087.
B) On Serial Numbers ME-1 through ME-164, ME-166, ME-168 through ME-181, ME-184 through ME-193, ME-195 and ME-198 visually inspect and, if necessary, replace the stop bolt nuts for the rudder bell crank with self-locking nuts in accordance with procedures set forth in Beechcraft Service Instructions Number 1087.
C) Aircraft may be flown in accordance with Federal Aviation Regulation 21.197 to a location where this AD can be accomplished.
D) Any equivalent method of compliance with this AD must be approved by the Chief, Engineering and Manufacturing Branch, FAA, Central Region.
This amendment becomes effective November 23, 1979.