| AD Number | 56-16-02 | Status | Active |
| Effective Date | Not specified | Issue Date | Not specified |
| Docket Number | Unknown | Amendment | N/A |
| Product Type | ["Aircraft"] | Product Subtype | ["Large Airplane"] |
| CFR Part | --- - Part 39 | CFR Section | N/A |
| Citation | This information is not available. | ||
| Manufacturer(s) | Lockheed Aircraft Corporation |
| Model(s) | 1049-54 1049B-55 (Navy R7V-1) 1049C-55 1049D-55 1049E-55 1049F-55 (USAF C-121C) 1049G-82 1049H-82 149-46 49-46 649-79 649A-79 749-79 749A-79 |
56-16-02 LOCKHEED: Applies to All Models 49, 149, 649, 749 and 1049 Series Aircraft Equipped With Bendix Eclipse-Pioneer Type PB-10 Series Automatic Pilot Installations.
Compliance required as indicated.
Numerous instances of fatigue failures have been reported in the side webs of the Bendix Eclipse-Pioneer Type DQ-15 Series servo disconnect mounting brackets in the primary flight control system. Since complete failure could result in disabling the flight control system, the following must be accomplished as indicated:
1. The rudder and elevator servo disconnect mounting bracket installations in the primary flight control system must be inspected by dye penetrant or equivalent method, at 125-hour intervals until item 2 is accomplished. Defective servo mounting brackets must be discarded.
2. To be accomplished as soon as possible but not to exceed next overhaul period after parts become available. The rudder and elevator servo must be reinforced by installation of a secondary servo support bracket to provide additional support and vibration dampening.
(Bendix Eclipse-Pioneer Service Bulletin No. 858 and Lockheed Service Bulletins Nos. 49-864 and 1049-2830 also cover this subject.)