AD 98-14-14 ACTIVE

This amendment adopts a new airworthiness directive (AD), applicable to certain McDonnell Douglas Model DC-3 and DC-3C series airplanes, that requires revising the Airplane Flight Manual (AFM) to modify the limitation that prohibits positioning the power levers below the flight idle stop during flight, and to provide a statement of the consequences of positioning the power levers below the flight idle stop during flight. This amendment is prompted by incidents and accidents involving airplanes equipped with turboprop engines in which the ground propeller beta range was used improperly during flight. The actions specified by this AD are intended to prevent loss of airplane controllability, or engine overspeed and consequent loss of engine power caused by the power levers being positioned below the flight idle stop while the airplane is in flight.

Final rule.

98-14-14 MCDONNELL DOUGLAS: Amendment 39-10647. Docket 97-NM-72-AD.\n\n\tApplicability: All turbopropeller-powered McDonnell Douglas Model DC-3 and DC-3C series airplanes, certificated in any category.\n\n\tNOTE 1: This AD applies to each airplane identified in the preceding applicability provision, regardless of whether it has been modified, altered, or repaired in the area subject to the requirements of this AD. For airplanes that have been modified, altered, or repaired so that the performance of the requirements of this AD is affected, the owner/operator must request approval for an alternative method of compliance in accordance with paragraph (c) of this AD. The request should include an assessment of the effect of the modification, alteration, or repair on the unsafe condition addressed by this AD; and, if the unsafe condition has not been eliminated, the request should include specific proposed actions to address it.\n\n\tCompliance: Required as indicated, unless accomplished previously.\n\n\tTo prevent loss of airplane controllability, or engine overspeed and consequent loss of engine power caused by the power levers being positioned below the flight idle stop while the airplane is in flight, accomplish the following:\n\n\t(a)\tFor turbopropeller-powered McDonnell Douglas Model DC-3 and DC-3C series airplanes on which Rolls-Royce Dart 510 engines are installed: Within 30 days after the effective date of this AD, revise the Limitations Section of the FAA-approved Airplane Flight Manual (AFM) to include the following statements. This action may be accomplished by inserting a copy of this AD into the AFM.\n\n\t"Positioning of power levers below the flight idle stop (i.e., including ground fine pitch) while the airplane is in flight is prohibited. Such positioning may lead to loss of airplane control or may result in an overspeed condition with consequent loss of engine power."\n\n\t(b)\tFor turbopropeller-powered McDonnell Douglas Model DC-3 and DC-3C series airplanes other than those identified in paragraph (a) of this AD: Within 30 days after the effective date of this AD, revise the Limitations Section of the FAA-approved Airplane Flight Manual (AFM) to include the following statements. This action may be accomplished by inserting a copy of this AD into the AFM.\n\n\t"Positioning of power levers below the flight idle stop while the airplane is in flight is prohibited. Such positioning may lead to loss of airplane control or may result in an overspeed condition with consequent loss of engine power."\n\n\t(c)\tAn alternative method of compliance or adjustment of the compliance time that provides an acceptable level of safety may be used if approved by the Manager, Los Angeles Aircraft Certification Office (ACO), FAA, Transport Airplane Directorate. Operators shall submit their requests through an appropriate FAA Principal Operations Inspector, who may add comments and then send it to the Manager, Los Angeles ACO.\n\n\tNOTE 2: Information concerning the existence of approved alternative methods of compliance with this AD, if any, may be obtained from the Los Angeles ACO.\n\n\t(d)\tSpecial flight permits may be issued in accordance with sections 21.197 and 21.199 of the Federal Aviation Regulations (14 CFR 21.197 and 21.199) to operate the airplane to a location where the requirements of this AD can be accomplished.\n\n\t(e)\tThis amendment becomes effective on August 11, 1998.

A proposal to amend part 39 of the Federal Aviation Regulations (14 CFR part 39) to include an airworthiness directive (AD) that is applicable to certain McDonnell Douglas Model DC-3 and DC-3C series airplanes was published in the Federal Register on January 8, 1998 (63 FR 1072). That action proposed to require revising the Limitations Section of the Airplane Flight Manual (AFM) to prohibit the positioning of the power levers below the flight idle stop while the airplane is in flight, and to add a statement of the consequences of positioning the power levers below the flight idle stop while the airplane is in flight.\n\nComments\n\n\tInterested persons have been afforded an opportunity to participate in the making of this amendment. No comments were submitted in response to the proposal or the FAA's determination of the cost to the public.\n\nConclusion\n\n\tThe FAA has determined that air safety and the public interest require the adoption of the rule as proposed.\n\nInterim Action\n\n\tThis is considered interim action until final action is identified, at which time the FAA may consider further rulemaking.\n\nCost Impact\n\n\tThere are approximately 21 turbopropeller-powered McDonnell Douglas Model DC-3 and DC-3C series airplanes of the affected design in the worldwide fleet. The FAA estimates that 5 airplanes of U.S. registry will be affected by this AD, that it will take approximately 1 work hour per airplane to accomplish the required actions, and that the average labor rate is $60 per work hour. Based on these figures, the cost impact of the AD on U.S. operators is estimated to be $300, or $60 per airplane.\n\n\tThe cost impact figure discussed above is based on assumptions that no operator has yet accomplished any of the requirements of this AD action, and that no operator would accomplish those actions in the future if this AD were not adopted.\n\nRegulatory Impact\n\n\tThe regulations adopted herein will not have substantial directeffects on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government. Therefore, in accordance with Executive Order 12612, it is determined that this final rule does not have sufficient federalism implications to warrant the preparation of a Federalism Assessment.\n\n\tFor the reasons discussed above, I certify that this action (1) is not a "significant regulatory action" under Executive Order 12866; (2) is not a "significant rule" under DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and (3) will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act. A final evaluation has been prepared for this action and it is contained in the Rules Docket. A copy of it may be obtained from the Rules Docket at the location provided under the caption "ADDRESSES."\n\nList of Subjects in 14 CFR Part 39\n\n\tAir transportation, Aircraft, Aviation safety, Safety.\n\nAdoption of the Amendment\n\n\tAccordingly, pursuant to the authority delegated to me by the Administrator, the Federal Aviation Administration amends part 39 of the Federal Aviation Regulations (14 CFR part 39) as follows:\n\nPART 39 - AIRWORTHINESS DIRECTIVES\n\n\t1. The authority citation for part 39 continues to read as follows:\n\nAuthority: 49 U.S.C. 106(g), 40113, 44701. \n\n§ 39.13 (Amended)\n\n\t2. Section 39.13 is amended by adding the following new airworthiness directive:

Information pertaining to this amendment may be examined at the Federal Aviation Administration (FAA), Transport Airplane Directorate, Rules Docket, 1601 Lind Avenue, SW., Renton, Washington; or at the FAA, Los Angeles Aircraft Certification Office, 3960 Paramount Boulevard, Lakewood, California.

Frank Hoerman, Aerospace Engineer, Flight Test Branch, ANM-160L, FAA, Los Angeles Aircraft Certification Office, 3960 Paramount Boulevard, Lakewood, California 90712; telephone (562) 527-5371; fax (562) 625-5210.