| AD Number | 92-06-10 | Status | Superseded |
| Effective Date | April 17, 1992 | Issue Date | Not specified |
| Docket Number | Unknown | Amendment | 39-8190 |
| Product Type | ["Aircraft"] | Product Subtype | ["Small Airplane"] |
| CFR Part | --- - Part 39 | CFR Section | N/A |
| Citation | This information is not available. | ||
| Manufacturer(s) | SOCATA |
| Model(s) | MS 892A-150 MS 892E-150 MS 893A MS 893E MS 894A MS 894E Rallye 235 E Rallye 235C |
| Superseded By | 2016-08-08 |
92-06-10 SOCATA GROUPE AEROSPATIALE: Amendment 39-8190; Docket No. 91-CE-81-AD.
Applicability: Morane Saulnier Models MS892A150, MS892E150, MS893A, MS893E, MS894A, and MS894E airplanes (all serial numbers); and Rallye Models 235C and 235E airplanes (all serial numbers), certificated in any category.
Compliance: Required initially upon the accumulation of 500 hours time-in-service (TIS) or within the next 50 hours TIS after the effective date of this AD, whichever occurs later, and thereafter as indicated, unless already accomplished.
To prevent nose wheel axle fatigue failure, accomplish the following:
(a) Dye penetrant inspect the nose wheel axle assembly for cracks in accordance with the instructions in DESCRIPTION: 1) of SOCATA Groupe AEROSPATIALE Service Bulletin No. 150, dated June 1991.
(1) If cracks are found, prior to further flight, replace the nose wheel axle assembly in accordance with the applicable maintenance manual, and reinspect thereafterat intervals not to exceed 500 hours TIS.
(2) If no cracks are found, reinspect thereafter at intervals not to exceed 500 hours TIS.
(b) At every 4th repetitive inspection interval (2,000 hours TIS) mandated in paragraphs (a)(1) and (a)(2) of this AD, replace the nose wheel axle attaching screws instead of reinstalling the existing screws as specified in the instructions of DESCRIPTION: 2) of SOCATA Groupe AEROSPATIALE SB No. 150, dated June 1991.
(c) Special flight permits may be issued in accordance with FAR 21.197 and 21.199 to operate the airplane to a location where the requirements of this AD can be accomplished.
(d) An alternative method of compliance or adjustment of the compliance times that provides an equivalent level of safety, may be approved by the Manager, Brussels Aircraft Certification Office, FAA, Europe, Africa, and Middle East Office, c/o American Embassy, B-1000 Brussels, Belgium. The request should be forwarded through an appropriate FAA Maintenance Inspector, who may add comments and then send it to the Manager, Brussels Aircraft Certification Office.
(e) The inspections and replacements required by this AD shall be done in accordance with SOCATA Groupe AEROSPATIALE Service Bulletin No. 150, dated June 1991. This incorporation by reference was approved by the Director of the Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR Part 51. Copies may be obtained from SOCATA Groupe AEROSPATIALE, Socata Product Support, Aeroport Tarbes-Ossun-Lourdes, B P 930, 65009 Tarbes Cedex, France. Copies may be inspected at the FAA, Central Region, Office of the Assistant Chief Counsel, Room 1558, 601 E. 12th Street, Kansas City, Missouri, or at the Office of the Federal Register, 1100 L Street, NW; Room 8401, Washington, DC.
(f) This amendment (39-8190) becomes effective on April 17, 1992.