| AD Number | 47-32-18 | Status | Active |
| Effective Date | Not specified | Issue Date | Not specified |
| Docket Number | Unknown | Amendment | N/A |
| Product Type | ["Aircraft"] | Product Subtype | ["Small Airplane"] |
| CFR Part | --- - Part 39 | CFR Section | N/A |
| Citation | This information is not available. | ||
| Manufacturer(s) | Bellanca Aircraft Corporation |
| Model(s) | 14-13 14-13-2 |
47-32-18 BELLANCA: (Was Service Note 1 of AD-773-5.) Applies to Models 14-13, 14-13-2 Serial Numbers 1075, and Up.
Compliance required prior to October 15, 1947, and after each 25 hours of operation.
Remove the washer and cotter pin from the clevis bolt which holds on the aileron idler sprocket located at the top center of the control yoke and back off the sprocket. Lubricate the entire bearing surface of the clevis pin with oil. Reinstall sprocket and washer, and safety with new cotter pin of same type (AN 380-3-3).
(Bellanca Service Bulletin No. 9 covers the same subject, and the installation of a grease fitting to avoid removing the sprocket.)