| AD Number | 48-01-03 | Status | Active |
| Effective Date | Not specified | Issue Date | Not specified |
| Docket Number | Unknown | Amendment | N/A |
| Product Type | ["Aircraft"] | Product Subtype | ["Small Airplane"] |
| CFR Part | --- - Part 39 | CFR Section | N/A |
| Citation | This information is not available. | ||
| Manufacturer(s) | Sky Enterprises, Inc. |
| Model(s) | RC-3 |
48-01-03 REPUBLIC: Applies to Model RC-3 Aircraft.
Compliance required by February 1, 1948, and at each 25-hour inspection until bushing is installed.
Inspect elevator trim tab for excessive play by holding control rod and measuring vertical movement of trailing edge. If play exceeds 1/8 inch, ream clevis pin hole in horn and press in a 1/4 inch O.D. cadmium plated steel bushing. If wear has reduced edge distance below 5/32 inch, a new horn with steel bushing should be installed.
(Republic Seabee Service Bulletin No. 20 dated October 10, 1947, and Supplement No. 1 thereto dated November 10, 1947, contain detailed information on this subject.)