Back to AD

AD 93-13-01 ACTIVE

Static Inverter
Key Information
AD Number 93-13-01 Status Active
Effective Date August 09, 1993 Issue Date Not specified
Docket Number 92-NM-239-AD Amendment 39-8614
Product Type ["Aircraft"] Product Subtype ["Large Airplane"]
CFR Part --- - Part 39 CFR Section N/A
Citation This information is not available.
Applicability
Manufacturer(s) The Boeing Company
Model(s) 757-200 Series 757-200CB Series 757-200PF Series 757-300 Series 767-200 Series 767-300 Series 767-300F Series
Regulatory Text

93-13-01 BOEING: Amendment 39-8614. Docket 92-NM-239-AD. \n\n\tApplicability: Model 757 series airplanes, line numbers 1 through 411 inclusive, 413 through 444 inclusive, 446 through 470 inclusive, and 472 through 480 inclusive; and Model 767 series airplanes, line numbers 1 through 451 inclusive; certificated in any category. \n\n\tCompliance: Required as indicated, unless accomplished previously. \n\n\tTo prevent the inability to restart the engines in the event of a dual engine flameout, accomplish the following: \n\n\t(a)\tWithin 12 months after the effective date of this AD, perform an examination of the nameplate on the static inverter to determine the part number of the static inverter, in accordance with Boeing Service Bulletin 757-24A0069, Revision 1, dated December 10, 1992 (for Model 757 series airplanes); or Boeing Alert Service Bulletin 767-24A0085, dated September 17, 1992 (for Model 767 series airplanes); as applicable. \n\n\t\t(1)\tIf Boeing part number (P/N) S282T004-7appears on the nameplate of the static inverter, prior to further flight, replace the static inverter with an improved model and perform an operational test, in accordance with the applicable service bulletin. \n\n\t\t(2)\tIf Boeing P/N S282T004-7 does not appear on the nameplate of the static inverter, no further action is required by this AD. \n\n\t(b)\tAs of the effective date of this AD, no person shall install a static inverter having P/N S282T004-7 on any Model 757 or 767 series airplane. \n\n\t(c)\tAn alternative method of compliance or adjustment of the compliance time that provides an acceptable level of safety may be used if approved by the Manager, Seattle Aircraft Certification Office (ACO), FAA, Transport Airplane Directorate. Operators shall submit their requests through an appropriate FAA Principal Maintenance Inspector, who may add comments and then send it to the Manager, Seattle ACO. \n\n\tNOTE: Information concerning the existence of approved alternative methods of compliance with this AD, if any, may be obtained from the Seattle ACO. \n\n\t(d)\tSpecial flight permits may be issued in accordance with FAR 21.197 and 21.199 to operate the airplane to a location where the requirements of this AD can be accomplished. \n\n\t(e)\tThe examination, replacement, and operational test shall be done in accordance with Boeing Service Bulletin 757-24A0069, Revision 1, dated December 10, 1992 (for Model 757 series airplanes); or Boeing Alert Service Bulletin 767-24A0085, dated September 17, 1992 (for Model 767 series airplanes); as applicable. This incorporation by reference was approved by the Director of the Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR Part 51. Copies may be obtained from Boeing Commercial Airplane Group, P.O. Box 3707, Seattle, Washington 98124-2207. Copies may be inspected at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington; or at the Office of the Federal Register, 800 North Capitol Street, NW., suite 700, Washington, DC. \n\n\t(f)\tThis amendment becomes effective on August 9, 1993.