47-51-04 CURTISS-WRIGHT Applies to All C-46 Series Airplanes Incorporating Hamilton Standard Propellers. \n\n\tCompliance required by March 1, 1948. \n\n\tTo eliminate failure of the propeller flexible feathering line, an antiheat shield shall be installed in accordance with the following instructions: \n\n\t(a)\tRemove the engine cowling adjacent to the propeller feathering line and inspect the flexible propeller feathering hose and lagging material (if installed) for disintegration and deterioration. Replace hose if deterioration is evident. \n\n\t(b)\tFabricate the antiheat shield and attaching clamps as shown in Figure 1. \n\n\t(c)\tPlace antiheat shield over the flexible hose and mount the shield on the engine mount by use of the clamps shown in Figure 1. The shield should be centered over the flexible hose. It may be necessary to rebend the metal feathering line slightly to achieve proper centering. \n\n\t(d)\tUpon completion of installation, check operation of propeller feathering system. \n\n\t(The above information is also contained in Army Air Forces Technical Order 01-25L- 105 dated April 2, 1947. Copies of this Technical Order are not available for distribution by the FAA.)