Back to AD

AD 74-22-07 ACTIVE

Compressor Rotor Disks
Key Information
AD Number 74-22-07 Status Active
Effective Date October 31, 1974 Issue Date Not specified
Docket Number Unknown Amendment 39-1997
Product Type ["Engine"] Product Subtype Not specified
CFR Part --- - Part 39 CFR Section N/A
Citation This information is not available.
Applicability
Manufacturer(s) Honeywell International Inc.
Model(s) T5313A
Regulatory Text

74-22-07 AVCO LYCOMING: Amendment 39-1997. Applies to all Avco Lycoming T5313A turboshaft engines.
Compliance required, unless already accomplished, prior to the accumulation of 100 hours in service after the effective date of this AD.
To prevent possible compressor disk or centrifugal impeller assembly failures leading to partial or complete loss of engine power, remove and replace the first, second, third, fourth, and fifth stage compressor rotor disks and centrifugal impeller assemblies in accordance with the table below.

Remove P/N
1st Stage Compressor 1-100-700-05
Rotor Disk Assembly
Socket Head Cap Screw 1-100-214-06
2nd Stage Compressor 1-100-710-05
Rotor Disk Assembly 1-100-710-09
1-100-710-10
3rd Stage Compressor 1-100-230-06
Rotor Disk Assembly 1-100-230-07
4th Stage Compressor 1-100-240-08
Rotor Disk Assembly 1-100-240-10
1-100-240-15
5th Stage Compressor 1-100-450-09
Rotor Disk Assembly
1st Stage Compressor 1-100-201-05
Rotor Spacer
2nd Stage Compressor 1-100-202-03
Rotor Spacer
3rd Stage Compressor 1-100-203-03
Rotor Spacer
4th Stage Compressor 1-100-204-06
Rotor Spacer
5th Stage Compressor 1-100-416-07
Rotor Spacer
Sleeve Seal 1-100-482-01
Centrifugal Compressor 1-100-440-07
Impeller Assembly
Compressor Rotor 1-100-207-05
Sleeve
Compressor Rear Shaft 1-100-137-04

Install P/N
Front Shaft Assembly 1-101-080-01
Socket Head Cap Screw 1-100-506-02
Compressor Rotor 1-101-090-02
Subassembly
Centrifugal Compressor 1-100-078-08
Impeller Assembly
Compressor Rear Shaft 1-100-501-01
Lock Cup Washer 1-100-148-01
Double Hexagon Extended 1-100-502-02
Washer Head Bolt

Upon submission of substantiating data through an FAA Maintenance Inspector, the Chief, Engineering and Manufacturing Branch, FAA, New England Region, may adjust the compliance time.
NOTE: (Avco Lycoming Service BulletinNumber 0037 pertains to this subject.)
This amendment is effective October 31, 1974.