Back to AD

AD 83-13-08 ACTIVE

Placard -Autopilot
Key Information
AD Number 83-13-08 Status Active
Effective Date July 18, 1983 Issue Date Not specified
Docket Number Unknown Amendment 39-4678
Product Type ["Aircraft"] Product Subtype ["Large Airplane"]
CFR Part --- - Part 39 CFR Section N/A
Citation This information is not available.
Applicability
Manufacturer(s) The Boeing Company
Model(s) 747-100 Series 747-100B Series 747-100B SUD Series 747-200B Series 747-200C Series 747-200F Series 747-300 Series 747-400 Series 747-400D Series 747-400F Series 747SR Series
Regulatory Text

83-13-08 BOEING: Amendment 39-4678. Applies to all model 747 airplanes, except the 747SP, certificated in all categories equipped with either the Landing Control Logic Unit (LCLU) or Landing Rollout Control Unit (LRCU) automatic landing systems and either Collins Low Range Radio Altimeter (LRRA), Model 860F-4, or Bendix Low Range Radio Altimeter, Model ALA 51A. To prevent hard landing due to false altitude information from the LRRA to the autopilot, accomplish the following, unless already accomplished: \n\n\tA.\tWithin 15 days after the effective date of this AD, install a placard on the autopilot P10 mode control panel which reads as follows: "DO NOT USE AUTOPILOT BELOW 50 FT. ON WET RUNWAYS." The placard may be removed when either paragraph B, C, or D below is accomplished. \n\n\tB.\tRemove Collins Model 860F-4 LRRA (P/N 622-3890-0XX), if installed, and perform Collins Service Bulletin 860F-4, Service Bulletin #8. Modified units become P/N 622- 3890-1XX. Install modified, orproduction equivalents, according to the Boeing Service Bulletin 747-34A2225. \n\n\tC.\tRemove Bendix Series ALA 51A LRRA (P/N 2067631-05XX or -51XX), if installed, and perform Bendix Service Bulletin M-1632-(ALA-51A-34-56). Modified units become P/N 2067631-53XX. Install modified, or production equivalents, according to Boeing Service Bulletin 747-34A2226. \n\n\tD.\tAlternate means of compliance which provide an equivalent level of safety may be used when approved by the Manager, Seattle Aircraft Certification Office, FAA, Northwest Mountain Region. \n\n\tAll persons affected by this proposal who have not already received the Service Bulletins may obtain copies upon request to Boeing, Collins Air Transport Division, or Bendix Corporation as appropriate. These documents may also be examined at the FAA, Northwest Mountain Region, 9010 East Marginal Way South, Seattle, Washington. \n\n\tThis amendment becomes effective July 18, 1983.