| AD Number | 60-17-01 | Status | Active |
| Effective Date | Not specified | Issue Date | Not specified |
| Docket Number | Unknown | Amendment | N/A |
| Product Type | ["Propeller"] | Product Subtype | Not specified |
| CFR Part | --- - Part 39 | CFR Section | N/A |
| Citation | This information is not available. | ||
| Manufacturer(s) | Pacific Propeller, Inc. |
| Model(s) | A6441FN-606 |
60-17-01 AERO PRODUCTS: Amdt. 193 Part 507 Federal Register August 19, 1960. Applies to A6441FN-606 Propeller Installed On Lockheed 188 Series Aircraft.
Compliance required as indicated.
As a result of investigations, it has been determined that the following must be accomplished to minimize the possible occurrence of propeller roughness and/or failures:
Not later than November 1, 1960, the thrust member thickness must be determined per Allison Propeller Bulletin 63-127. All blades that do not meet thrust member thickness as prescribed in Allison Propeller Bulletin 63-127 must be removed from service prior to further flight. Concurrently with this inspection all blades shall be classified aerodynamically per Allison Propeller Bulletin 63-125. (Allison telegram to all operators dated May 19, 1960, and Allison Propeller Bulletins Nos. 63-125 and 63-127 cover this same subject.)