| AD Number | 62-19-03 | Status | Active |
| Effective Date | August 28, 1962 | Issue Date | August 17, 1962 |
| Docket Number | Unknown | Amendment | N/A |
| Product Type | ["Aircraft"] | Product Subtype | ["Small Airplane"] |
| CFR Part | --- - Part 39 | CFR Section | --- - _EMPTY_ |
| Citation | Federal Register: August 23, 1962 | ||
| Manufacturer(s) | Piper Aircraft Inc. |
| Model(s) | PA-28-150 PA-28-160 PA-28-180 |
62-19-03 PIPER: Amdt. 478 Part 507 Federal Register August 23, 1962. Applies to All Model PA-28 Aircraft, Serial Numbers 28-1 to 28-314 Inclusive, 28-317 to 28-326 Inclusive, 28- 328 to 28-331 Inclusive, 28-333 to 28-341 Inclusive, 28-343, 28-345 to 28-348 Inclusive, 28- 351, 28-352, 28-356, 28-359, and 28-365.
Compliance required as indicated.
There has been inflight failure of the propeller attach bolts due to under-torquing of the bolts. In order to preclude the loss of the propeller due to the failure of the bolts, the following is required:
(a) Within the next 10 hours' time in service after the effective date of this AD, unless already accomplished, remove the propeller spinner and remove each propeller attach bolt.
(b) Inspect for cracks in the bolt in the area of the threads using magnetic particle or FAA-approved equivalent inspection method in conjunction with a 5-power or higher magnifying glass. Inspect the grip shank for brinelled surfaces with a5-power or higher magnifying glass.
(c) If cracks are found or if the bolt is brinelled on the grip shank, replace with new bolts, AN 76-41S. Torque to 300 inch-pounds.
(d) If cracks are not found, reinstall the bolts and torque to 300 inch-pounds.
(e) In lieu of the inspection requirement of (b), new bolts, AN 76-41S, may be installed and torqued to 300 inch-pounds.
(Piper Service Bulletin No. 209, dated April 17, 1962, covers this same subject.)
This directive effective August 28, 1962.