AD 2021-12-09 ACTIVE

The FAA is adopting a new airworthiness directive (AD) for all Airbus Helicopters Deutschland GmbH (AHD) Model MBB-BK 117 D-2 helicopters. This AD was prompted by a short circuit in a yaw trim actuator connector that occurred during production electrical tests. This AD requires replacing certain wire harness trim connector backshells (backshells), as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.

Final rule.

The Amendment \n\n\n\tAccordingly, under the authority delegated to me by the Administrator, the FAA amends 14 CFR part 39 as follows: \n\nPART 39--AIRWORTHINESS DIRECTIVES \n\n0 1. The authority citation for part 39 continues to read as follows: \n\n\n\tAuthority: 49 U.S.C. 106(g), 40113, 44701. \n\n\n\nSec. 39.13 (Amended) \n\n0 2. The FAA amends Sec. 39.13 by adding the following new airworthiness directive: \n\n2021-12-09 Airbus Helicopters Deutschland GmbH (AHD): Amendment 39- 21596; Docket No. FAA-2021-0256; Project Identifier MCAI-2020-00480- R. \n\n((Page 33110)) \n\n(a) Effective Date \n\n\n\tThis airworthiness directive (AD) is effective July 29, 2021. \n\n(b) Affected Airworthiness Directives \n\n\n\tNone. \n\n(c) Applicability \n\n\n\tThis AD applies to Airbus Helicopters Deutschland GmbH (AHD) Model MBB-BK 117 D-2 helicopters, certificated in any category, having an affected part as defined in European Union Aviation Safety Agency (EASA) AD 2019-0198, dated August 15, 2019 (EASA AD 2019- 0198). \n\n(d) Subject \n\n\n\tJoint Aircraft System Component (JASC) Code 2700, Flight Control System. \n\n(e) Reason \n\n\n\tThis AD was prompted by a short circuit in a yaw trim actuator connector that occurred during production electrical tests. Subsequent investigations determined that a sharp edge in the wire harness trim connector backshell damaged the wiring insulation. The FAA is issuing this AD to address an unsafe condition that could result in yaw or pitch trim runaway and subsequent loss of control of the helicopter. \n\n(f) Compliance \n\n\n\tComply with this AD within the compliance times specified, unless already done. \n\n(g) Requirements \n\n\n\tExcept as specified in paragraph (h) of this AD: Comply with all required actions and compliance times specified in, and in accordance with EASA AD 2019-0198. \n\n(h) Exceptions to EASA AD 2019-0198 \n\n\n\t(1) Where EASA AD 2019-0198 refers to its effective date, this AD requires using the effective date of this AD.(2) Where paragraph (1) of EASA AD 2019-0198 specifies to replace each affected part with a serviceable part within 9 months, this AD requires replacing each affected part with a serviceable part within 30 hours time-in-service after the effective date of this AD. \n\t(3) Although the service information referenced in EASA AD 2019- 0198 specifies to discard certain parts, this AD requires removing those parts from service. \n\t(4) Where the service information referenced in EASA AD 2019- 0198 specifies to use tooling, equivalent tooling may be used. \n\t(5) Paragraph (2) of EASA AD 2019-0198 does not apply to this AD; this AD requires compliance with paragraph (i) of this AD. \n\t(6) The ''Remarks'' section of EASA AD 2019-0198 does not apply to this AD. \n\n(i) Parts Installation Prohibition \n\n\n\tAs of the effective date of this AD, do not install a wire harness trim connector backshell identified in paragraph (c) of this AD on any helicopter. \n\n\n\t(j) Alternative Methods of Compliance (AMOCs) \n\n\n\t(1) The Manager, International Validation Branch, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or local Flight Standards District Office, as appropriate. If sending information directly to the manager of the International Validation Branch, send it to the attention of the person identified in paragraph (k) of this AD. Information may be emailed to: 9-AVS-AIR-730-AMOC@faa.gov. \n\t(2) Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the local flight standards district office/certificate holding district office. \n\n(k) Related Information \n\n\n\tFor more information about this AD, contact Katherine Venegas, Aviation Safety Engineer, Los Angeles ACO Branch, Compliance & Airworthiness Division, FAA, 3960 Paramount Blvd., Lakewood, CA 90712; telephone (562) 627-5353; email katherine.venegas@faa.gov. \n\n(l) Material Incorporated by Reference \n\n\n\t(1) The Director of the Federal Register approved the incorporation by reference (IBR) of the service information listed in this paragraph under 5 U.S.C. 552(a) and 1 CFR part 51. \n\t(2) You must use this service information as applicable to do the actions required by this AD, unless this AD specifies otherwise. \n\t(i) European Union Aviation Safety Agency (EASA) AD 2019-0198, dated August 15, 2019. \n\t(ii) (Reserved) \n\t(3) For EASA AD 2019-0198, contact the EASA, Konrad-Adenauer- Ufer 3, 50668 Cologne, Germany; telephone +49 221 8999 000; email ADs@easa.europa.eu; internet www.easa.europa.eu. You may find this EASA AD on the EASA website at https://ad.easa.europa.eu. \n\t(4) You may view this service information at the FAA, Office of the Regional Counsel, Southwest Region, 10101 Hillwood Pkwy., Room 6N-321, Fort Worth, TX 76177. For information on the availability of this material at the FAA, call (817) 222-5110. This material may be found in the AD docket on the internet at https://www.regulations.gov by searching for and locating Docket No. FAA- 2021-0256. \n\t(5) You may view this material that is incorporated by reference at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, email fedreg.legal@nara.gov, or go to https://www.archives.gov/federal-register/cfr/ibr-locations.html. \n\n\n\tIssued on May 28, 2021. Gaetano A. Sciortino, Deputy Director for Strategic Initiatives, Compliance & Airworthiness Division, Aircraft Certification Service. (FR Doc. 2021-13127 Filed 6-23-21; 8:45 am) BILLING CODE 4910-13-P

Background \n\n\n\tEASA, which is the Technical Agent for the Member States of the European Union, has issued EASA AD 2019-0198, dated August 15, 2019 (EASA AD 2019-0198), to correct an unsafe condition for all Airbus Helicopters Deutschland GmbH (AHD), formerly Eurocopter Deutschland GmbH, Model MBB-BK117 D-2 helicopters. \n\tThe FAA issued a notice of proposed rulemaking (NPRM) to amend 14 CFR part 39 by adding an AD that would apply to Airbus Helicopters Deutschland GmbH Model MBB-BK 117 D-2 helicopters. The NPRM published in the Federal Register on April 2, 2021 (86 FR 17322). The NPRM was prompted by a short circuit in a yaw trim actuator connector that occurred during production electrical tests. Subsequent investigations determined that a sharp edge in the backshell damaged the wiring insulation. The NPRM proposed to require replacing certain backshells, as specified in an EASA AD. \n\tThe FAA is issuing this AD to address an unsafe condition that could result in yaw or pitch trim runaway and subsequent loss of control of the helicopter. See EASA AD 2019-0198 for additional background information. \n\nDiscussion of Final Airworthiness Directive \n\nComments \n\n\n\tThe FAA gave the public the opportunity to participate in developing this final rule. The FAA received comments from one commenter; however, none of the comments requested a change to the requirements proposed by the NPRM or the determination of the cost to the public. \n\nConclusion \n\n\n\tThe FAA reviewed the relevant data, considered the comments received, and determined that air safety and the public interest require adopting this final rule as proposed. \n\nRelated Service Information Under 1 CFR Part 51 \n\n\n\tEASA AD 2019-0198 specifies replacing backshells part number (P/N) M85049/90-13W02 if manufactured by AMPHENOL or if the manufacturer is unknown (affected part) with backshells P/N M85049/90-13W02 not manufactured by AMPHENOL (serviceable part). EASA AD 2019-0198 also prohibits the (re-)installation of an affected part. \n\tThis material is reasonably available because the interested parties have access to it through their normal course of business or by the means identified in the ADDRESSES section. \n\nDifferences Between This AD and the EASA AD \n\n\n\tEASA AD 2019-0198 applies to all Model MBB-BK117 D-2 helicopters, whereas this AD applies to that model helicopter with an affected part installed instead. EASA AD 2019-0198 requires replacing each affected part with a serviceable part within 9 months, whereas this AD requires that replacement within 30 hours time-in-service instead. \n\nCosts of Compliance \n\n\n\tThe FAA estimates that this AD affects 30 helicopters of U.S. Registry. Labor rates are estimated at $85 per work-hour. Based on these numbers, the FAA estimates that operators may incur the following costs in order to comply with this AD. \n\tReplacing each backshell takes about 8 work-hours and parts cost $220, for an estimated cost of $900 per backshell. \n\nAuthority for This Rulemaking \n\n\n\tTitle 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. Subtitle VII: Aviation Programs, describes in more detail the scope of the Agency's authority. \n\tThe FAA is issuing this rulemaking under the authority described in Subtitle VII, Part A, Subpart III, Section 44701: General requirements. Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action. \n\nRegulatory Findings \n\n\n\tThis AD will not have federalism implications under Executive Order 13132.This AD will not have a substantial direct effect on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government. \n\tFor the reasons discussed above, I certify that this AD: \n\t(1) Is not a ''significant regulatory action'' under Executive Order 12866, \n\t(2) Will not affect intrastate aviation in Alaska, and \n\t(3) Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act. \n\nList of Subjects in 14 CFR Part 39 \n\n\n\tAir transportation, Aircraft, Aviation safety, Incorporation by reference, Safety.

The Director of the Federal Register approved the incorporation by reference of a certain publication listed in this AD as of July 29, 2021. \n\nADDRESSES: For material incorporated by reference (IBR) in this AD, contact the EASA, Konrad-Adenauer-Ufer 3, 50668 Cologne, Germany; telephone +49 221 8999 000; email ADs@easa.europa.eu; internet www.easa.europa.eu. You may find this \n\n((Page 33109)) \n\nmaterial on the EASA website at https://ad.easa.europa.eu. You may view this material at the FAA, Office of the Regional Counsel, Southwest Region, 10101 Hillwood Pkwy., Room 6N-321, Fort Worth, TX 76177. For information on the availability of this material at the FAA, call (817) 222-5110. It is also available in the AD docket on the internet at https://www.regulations.gov by searching for and locating Docket No. FAA-2021-0256. \n\nExamining the AD Docket \n\n\n\tYou may examine the AD docket on the internet at https://www.regulations.gov by searching for and locating Docket No. FAA-2021-0256; or in person at Docket Operations between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains this final rule, any comments received, and other information. The address for Docket Operations is U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE, Washington, DC 20590.

Katherine Venegas, Aviation Safety Engineer, Los Angeles ACO Branch, Compliance & Airworthiness Division, FAA, 3960 Paramount Blvd., Lakewood, CA 90712; telephone (562) 627- 5353; email katherine.venegas@faa.gov.