AD 2010-21-13 ACTIVE

We are adopting a new airworthiness directive (AD) for the products listed above. This AD requires installing a support bracket and coupler on the left and right wing-to-fuselage transition, and metallic overbraid on the left and right leading edge wire assembly. This AD was prompted by fuel system reviews conducted by the manufacturer, as well as reports that the fuel quantity system was affected by lightning-induced transients. We are issuing this AD to prevent lightning-induced transients to the fuel quantity indication system, which could cause voltage levels to go beyond original design levels between fuel tank probes and structure, and become a potential ignition source at the fuel tank, which, in combination with flammable fuel vapors, could result in a fuel tank explosion and consequent loss of the airplane.

Final rule.

2010-21-13 McDonnell Douglas Corporation: Amendment 39-16473; Docket No. FAA-2010-0672; Directorate Identifier 2010-NM-047-AD. \n\nEffective Date \n\n\t(a) This AD is effective November 18, 2010. \n\nAffected ADs \n\n\t(b) None. \n\nApplicability \n\n\t(c) This AD applies to McDonnell Douglas Corporation Model DC- 10-10, DC-10-10F, DC-10-30, DC-10-30F (KDC-10), DC-10-40, and DC-10- 40F airplanes, certificated in any category, as identified in Boeing Service Bulletin DC10-28-262, Revision 1, dated June 9, 2010. \n\nSubject \n\n\t(d) Air Transport Association (ATA) of America Code 28: Fuel. \n\nUnsafe Condition \n\n\t(e) This AD results from fuel system reviews conducted by the manufacturer. The Federal Aviation Administration is issuing this AD to prevent lightning-induced transients to the fuel quantity indication system, which could cause voltage levels to go beyond original design levels between fuel tank probes and structure and become a potential ignition source at the fuel tank, which, in combination with flammable fuel vapors, could result in a fuel tank explosion and consequent loss of the airplane. \n\nCompliance \n\n\t(f) You are responsible for having the actions required by this AD performed within the compliance times specified, unless the actions have already been done. \n\nInstallation \n\n\t(g) Within 60 months after the effective date of this AD, install a support bracket and coupler on the left and right wing-to- fuselage transition, and metallic overbraid on the left and right leading edge wire assembly, in accordance with the Accomplishment Instructions of Boeing Service Bulletin DC10-28-262, Revision 1, dated June 9, 2010. \n\nInstallation According to Previous Issue of Service Bulletin \n\n\t(h) Installing a support bracket and coupler on the left and right wing-to-fuselage transition, and metallic overbraid on the left and right leading edge wire assembly, is also acceptable for compliance with the requirements of paragraph (g) of this AD if done before the effective date of this AD in accordance with the Accomplishment Instructions of Boeing Service Bulletin DC10-28-262, dated January 6, 2010. \n\nAlternative Methods of Compliance (AMOCs) \n\n\t(i)(1) The Manager, Los Angeles Aircraft Certification Office, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. Send information to ATTN: Samuel Lee, Aerospace Engineer, Propulsion Branch, ANM-140L, FAA, Los Angeles Aircraft Certification Office (ACO), 3960 Paramount Boulevard, Lakewood, California 90712-4137; telephone (562) 627- 5262; fax (562) 627-5210. \n\t(2) To request a different method of compliance or a different compliance time for this AD, follow the procedures in 14 CFR 39.19. Before using any approved AMOC on any airplane to which the AMOC applies, notify your principal maintenance inspector (PMI) or principal avionics inspector (PAI), as appropriate, or lacking a principal inspector, your local Flight Standards District Office. The AMOC approval letter must specifically reference this AD. \n\nRelated Information \n\n\t(j) For more information about this AD, contact Samuel Lee, Aerospace Engineer, Propulsion Branch, ANM-140L, FAA, Los Angeles Aircraft Certification Office (ACO), 3960 Paramount Boulevard, Lakewood, California 90712-4137; telephone (562) 627-5262; fax (562) 627-5210; e-mail samuel.lee@faa.gov. \n\nMaterial Incorporated by Reference \n\n\t(k) You must use Boeing Service Bulletin DC10-28-262, Revision 1, dated June 9, 2010, to do the actions required by this AD, unless the AD specifies otherwise. \n\t(1) The Director of the Federal Register approved the incorporation by reference of Boeing Service Bulletin DC10-28-262, Revision 1, dated June 9, 2010, under 5 U.S.C. 552(a) and 1 CFR part 51. \n\t(2) For service information identified in this AD, contact Boeing Commercial Airplanes, Attention: Data & Services Management, 3855 Lakewood Boulevard, MC D800-0019, Long Beach, California 90846- 0001; telephone 206-544-5000, extension 2; fax 206-766-5683; e-mail dse.boecom@boeing.com; Internet https://www.myboeingfleet.com. \n\t(3) You may review copies of the service information at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington. For information on the availability of this material at the FAA, call 425-227-1221. \n\t(4) You may also review copies of the service information that is incorporated by reference at the National Archives and Records Administration (NARA). For information on the availability of this material at an NARA facility, call 202-741-6030, or go to http:// www.archives.gov/federal_register/code_of_federal_regulations/ ibr_locations.html.

Discussion \n\n\tWe issued a notice of proposed rulemaking (NPRM) to amend 14 CFR part 39 to include an airworthiness directive (AD) that would apply to the specified products. That NPRM was published in the Federal Register on July 7, 2010 (75 FR 38943). That NPRM proposed to require installing a support bracket and coupler on the left and right wing-to-fuselage transition, and metallic overbraid on the left and right leading edge wire assembly. \n\nComments \n\n\tWe gave the public the opportunity to participate in developing this AD. We received no comments on the NPRM or on the determination of the cost to the public. \n\nConclusion \n\n\tWe reviewed the relevant data and determined that air safety and the public interest require adopting the AD as proposed except for minor editorial changes. We have determined that these minor changes: \n\tAre consistent with the intent that was proposed in the NPRM for correcting the unsafe condition; and \n\tDo not addany additional burden upon the public than was already proposed in the NPRM. \n\nCosts of Compliance \n\n\tWe estimate that this AD affects 61 airplanes of U.S. registry. \n\tWe estimate the following costs to comply with this AD: \n\n\tEstimated Costs \n\n\nAction\nLabor cost\nParts cost\nCost per product\nCost on U.S. operators\nInstallation\n28 work-hours X $85 per hour = $2,380\n$999\n$3,379\n$206,119\n\nAuthority for This Rulemaking \n\n\tTitle 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. Subtitle VII: Aviation Programs, describes in more detail the scope of the Agency's authority. \n\tWe are issuing this rulemaking under the authority described in Subtitle VII, Part A, Subpart III, Section 44701: "General requirements.'' Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action. \n\nRegulatory Findings \n\n\tThis AD will not have federalism implications under Executive Order 13132. This AD will not have a substantial direct effect on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government. \n\tFor the reasons discussed above, I certify that this AD: \n\t(1) Is not a "significant regulatory action'' under Executive Order 12866, \n\t(2) Is not a "significant rule'' under DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979), \n\t(3) Will not affect intrastate aviation in Alaska, and \n\t(4) Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act. \n\nList of Subjects in 14 CFR Part 39 \n\n\tAir transportation, Aircraft, Aviation safety, Incorporation by reference, Safety. \n\nAdoption of the Amendment \n\nAccordingly, under the authority delegated to me by the Administrator, the FAA amends 14 CFR part 39 as follows: \n\nPART 39--AIRWORTHINESS DIRECTIVES \n\n1. The authority citation for part 39 continues to read as follows: \n\n\tAuthority: 49 U.S.C. 106(g), 40113, 44701. \n\nSec. 39.13 (Amended) \n\n2. The FAA amends Sec. 39.13 by adding the following new airworthiness directive (AD):

For service information identified in this AD, contact Boeing Commercial Airplanes, Attention: Data & Services Management, 3855 Lakewood Boulevard, MC D800-0019, Long Beach, California 90846- 0001; telephone 206-544-5000, extension 2; fax 206-766-5683; e-mail dse.boecom@boeing.com; Internet https://www.myboeingfleet.com. You may review copies of the referenced service information at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington. For information on the availability of this material at the FAA, call 425-227-1221. \n\nExamining the AD Docket \n\n\tYou may examine the AD docket on the Internet at http:// www.regulations.gov; or in person at the Docket Management Facility between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains this AD, the regulatory evaluation, any comments received, and other information. The address for the Docket Office (phone: 800-647-5527) is Document Management Facility, U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue, SE., Washington, DC 20590.

Samuel Lee, Aerospace Engineer, Propulsion Branch, ANM-140L, FAA, Los Angeles Aircraft Certification Office (ACO), 3960 Paramount Boulevard, Lakewood, California 90712- 4137; telephone (562) 627-5262; fax (562) 627-5210; e-mail samuel.lee@faa.gov.