| AD Number | 2008-16-13 | Status | Active |
| Effective Date | September 09, 2008 | Issue Date | July 23, 2008 |
| Docket Number | FAA-2008-0413 | Amendment | 39-15631 |
| Product Type | ["Aircraft"] | Product Subtype | ["Large Airplane"] |
| CFR Part | --- - Part 39 | CFR Section | N/A |
| Citation | Federal Register: August 5, 2008 | ||
| Manufacturer(s) | The Boeing Company |
| Model(s) | 737-600 Series 737-700 Series 737-700C Series 737-800 Series 737-900 Series 737-900ER Series |
We are adopting a new airworthiness directive (AD) for certain Boeing Model 737-600, -700, -700C, -800, -900, and -900ER series airplanes. This AD requires replacing the pushrods for the left and right elevator tab control mechanisms with new, improved pushrods. This AD results from a report of a rod end fracture on a rudder power control unit (PCU) control rod, which is similar to the ones used for the elevator tab pushrods. Analysis revealed that the fractured rod end had an incorrect hardness, which had probably occurred during the manufacture of the control rod. We are issuing this AD to prevent fracture of the elevator tab pushrod ends, which could result in excessive in-flight vibrations of the elevator tab, possible loss of the elevator tab, and consequent loss of controllability of the airplane.
Final rule.
2008-16-13 Boeing: Amendment 39-15631. Docket No. FAA-2008-0413; Directorate Identifier 2008-NM-003-AD. \n\nEffective Date \n\n\t(a) This airworthiness directive (AD) is effective September 9, 2008. \n\nAffected ADs \n\n\t(b) None. \n\nApplicability \n\n\t(c) This AD applies to Boeing Model 737-600, -700, -700C, -800, -900, and -900ER series airplanes, certificated in any category; line numbers 1 through 2196 inclusive. \n\nUnsafe Condition \n\n\t(d) This AD results from a report of a rod end fracture on a rudder power control unit (PCU) control rod, which is similar to the ones used for the elevator tab pushrods. Analysis revealed that the fractured rod end had an incorrect hardness, which had probably occurred during the manufacture of the control rod. We are issuing this AD to prevent fracture of the elevator tab pushrod ends, which could result in excessive in-flight vibrations of the elevator tab, possible loss of the elevator tab, and consequent loss of controllability of the airplane. \n\nCompliance \n\n\t(e) Comply with this AD within the compliance times specified, unless already done. \n\nPushrod Replacement \n\n\t(f) At the time specified in paragraph 1.E., "Compliance,'' of Boeing Special Attention Service Bulletin 737-27-1284, dated November 28, 2007; except, where the service bulletin specifies a compliance time after the date on the service bulletin, this AD requires compliance within the specified compliance time after the effective date of this AD: Replace the pushrods for the left and right elevator tab control mechanisms with new, improved pushrods by doing all the actions in accordance with the Accomplishment Instructions of Boeing Special Attention Service Bulletin 737-27- 1284, dated November 28, 2007. \n\nParts Installation \n\n\t(g) As of the effective date of this AD, no person may install a pushrod assembly, part number 65-45166-24, on any airplane. \n\nAlternative Methods of Compliance (AMOCs) \n\n\t(h)(1) The Manager, Seattle Aircraft Certification Office (ACO), FAA, ATTN: Tamara Anderson, Aerospace Engineer, Airframe Branch, ANM-120S, FAA, Seattle ACO, 1601 Lind Avenue, SW., Renton, Washington 98057-3356; telephone (425) 917-6421; fax (425) 917-6590; has the authority to approve AMOCs for this AD, if requested, using the procedures found in 14 CFR 39.19. \n\t(2) To request a different method of compliance or a different compliance time for this AD, follow the procedures in 14 CFR 39.19. Before using any approved AMOC on any airplane to which the AMOC applies, notify your appropriate principal inspector (PI) in the FAA Flight Standards District Office (FSDO), or lacking a PI, your local FSDO. \n\t(3) An AMOC that provides an acceptable level of safety may be used for any repair required by this AD, if it is approved by an Authorized Representative for the Boeing Commercial Airplanes Delegation Option Authorization Organization who has been authorized by the Manager, Seattle ACO, to make those findings. For a repair method to be approved, the repair must meet the certification basis of the airplane. \n\nMaterial Incorporated by Reference \n\n\t(i) You must use Boeing Special Attention Service Bulletin 737- 27-1284, dated November 28, 2007, to do the actions required by this AD, unless the AD specifies otherwise. \n\t(1) The Director of the Federal Register approved the incorporation by reference of this service information under 5 U.S.C. 552(a) and 1 CFR part 51. \n\t(2) For service information identified in this AD, contact Boeing Commercial Airplanes, P.O. Box 3707, Seattle, Washington 98124-2207. \n\t(3) You may review copies of the service information incorporated by reference at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington; or at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call 202-741-6030, or go to: http://www.archives.gov/federal_register/code_of_federal_ regulations/ibr_locations.html.
Discussion \n\n\tWe issued a notice of proposed rulemaking (NPRM) to amend 14 CFR part 39 to include an airworthiness directive (AD) that would apply to certain Boeing Model 737-600, -700, -700C, -800, -900, and -900ER series airplanes. That NPRM was published in the Federal Register on April 24, 2008 (73 FR 22090). That NPRM proposed to require replacing the pushrods for the left and right elevator tab control mechanisms with new, improved pushrods. \n\nComments \n\n\tWe gave the public the opportunity to participate in developing this AD. We considered the two comments received. Boeing concurs with the contents of the NPRM, and Continental Airlines has no issues with the NPRM. \n\nConclusion \n\n\tWe reviewed the relevant data, considered the comments received, and determined that air safety and the public interest require adopting the AD as proposed. \n\nCosts of Compliance \n\n\tWe estimate that this AD affects 715 airplanes of U.S. registry. We also estimate that it takes about 4 work-hours per product to comply with this AD. The average labor rate is $80 per work-hour. Required parts cost about $8,036 per product. Based on these figures, we estimate the cost of this AD to the U.S. operators to be $5,974,540, or $8,356 per product. \n\nAuthority for This Rulemaking \n\n\tTitle 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. "Subtitle VII: Aviation Programs,'' describes in more detail the scope of the Agency's authority. \n\tWe are issuing this rulemaking under the authority described in "Subtitle VII, Part A, Subpart III, Section 44701: General requirements.'' Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action. \n\nRegulatory Findings \n\n\tThis AD will not have federalism implications under Executive Order 13132. This AD will not have a substantial direct effect on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government. \n\tFor the reasons discussed above, I certify that this AD: \n\t(1) Is not a "significant regulatory action'' under Executive Order 12866, \n\t(2) Is not a "significant rule'' under DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979), and \n\t(3) Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act. \n\tYou can find our regulatory evaluation and the estimated costs of compliance in the AD Docket. \n\nList of Subjects in 14 CFR Part 39 \n\n\tAir transportation, Aircraft, Aviation safety, Incorporation by reference, Safety. \n\nAdoption of the Amendment \n\nAccordingly, under the authority delegated to me by the Administrator, the FAA amends 14 CFR part 39 as follows: \n\nPART 39--AIRWORTHINESS DIRECTIVES \n\n1. The authority citation for part 39 continues to read as follows: \n\n\tAuthority: 49 U.S.C. 106(g), 40113, 44701. \n\nSec. 39.13 (Amended) \n\n2. The FAA amends Sec. 39.13 by adding the following new AD:
For service information identified in this AD, contact Boeing Commercial Airplanes, P.O. Box 3707, Seattle, Washington 98124- 2207. \n\nExamining the AD Docket \n\n\tYou may examine the AD docket on the Internet at http:// www.regulations.gov; or in person at the Docket Management Facility between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains this AD, the regulatory evaluation, any comments received, and other information. The address for the Docket Office (telephone 800-647-5527) is the Document Management Facility, U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue, SE., Washington, DC 20590.
Tamara Anderson, Aerospace Engineer, Airframe Branch, ANM-120S, FAA, Seattle Aircraft Certification Office, 1601 Lind Avenue, SW., Renton, Washington 98057-3356; telephone (425) 917-6421; fax (425) 917-6590.