| AD Number | 83-08-07 | Status | Active |
| Effective Date | May 09, 1983 | Issue Date | Not specified |
| Docket Number | Unknown | Amendment | 39-4643 |
| Product Type | ["Aircraft"] | Product Subtype | ["Small Airplane"] |
| CFR Part | --- - Part 39 | CFR Section | N/A |
| Citation | This information is not available. | ||
| Manufacturer(s) | Aermacchi S.p.A. |
| Model(s) | F.260 F.260B S.205 - 18/F S.205 - 18/R S.205 - 20/F S.205 - 20/R S.208 S.208A |
83-08-07 SIAI-MARCHETTI: Amendment 39-4643. Applies to Models S205-18 and S205-20 (serial numbers 1 through 5), S208 and S208A (serial numbers 1 through 4-64), and F260 and F260B (serial numbers 101 through 125, 2-26 through 2-75, 3-76, 3-77 through 3-81, 3-84, 502, 10-09, 20-01, 235, 237 through 243, 247 through 254, and 266 through 286) airplanes certificated in any category.
Compliance: Required as indicated, unless already accomplished.
To detect cracks in the propeller governor arm and preclude possible loss of propeller control, accomplish the following:
(a) Within the next 25 hours time-in-service after the effective date of this AD, unless already accomplished within the last 25 hours time-in-service, and thereafter at intervals not to exceed 50 hours time-in-service from the last inspection, visually inspect the propeller governor arm with a 5-power magnifier for cracks and breaks in accordance with the following:
(1) For the Model S205 and S208 airplanes, with "Instructions" paragraph (a), steps 1 through 4, of SIAI-Marchetti Service Bulletin No. 205B43A dated September 16, 1977.
(2) For the Model F260 and F260B airplanes, with "Instructions" paragraph (a), steps 1 through 4, of SIAI-Marchetti Service Bulletin No. 260B18A dated September 16, 1977.
(b) If a crack or break is detected as a result of an inspection required by paragraph (a) of this AD, before further flight, replace the propeller governor arm with a serviceable part in accordance with the following:
(1) For the Model S205 and S208 airplanes with "Instructions" paragraph (c), steps 1 through 10, of the SIAI-Marchetti Service Bulletin No. 205B43A dated September 16, 1977.
(2) For the Model F260 and F260B airplanes with "Instructions" paragraph (c), steps 1 through 10, of SIAI-Marchetti Service Bulletin No. 260B18A dated September 16, 1977.
(c) When propeller governor arm, Part No. 260-13-274-01 is installed, the inspections in paragraph (a)of this AD are no longer required.
(d) Any equivalent means of complying with this AD must be approved by Manager, Aircraft Certification Staff, AEU-100, Europe, Africa, and Middle East Office, FAA, c/o American Embassy, Brussels, Belgium.
This AD supersedes AD 77-14-16, Amendment 39-2959.
This amendment becomes effective on May 9, 1983.