AD 83-08-07

Active

Propeller Control

Key Information
83-08-07
Active
May 09, 1983
Not specified
Unknown
39-4643
Applicability
["Aircraft"]
["Small Airplane"]
Aermacchi S.p.A.
F.260 F.260B S.205 - 18/F S.205 - 18/R S.205 - 20/F S.205 - 20/R S.208 S.208A
Regulatory Text

83-08-07 SIAI-MARCHETTI: Amendment 39-4643. Applies to Models S205-18 and S205-20 (serial numbers 1 through 5), S208 and S208A (serial numbers 1 through 4-64), and F260 and F260B (serial numbers 101 through 125, 2-26 through 2-75, 3-76, 3-77 through 3-81, 3-84, 502, 10-09, 20-01, 235, 237 through 243, 247 through 254, and 266 through 286) airplanes certificated in any category.

Compliance: Required as indicated, unless already accomplished.

To detect cracks in the propeller governor arm and preclude possible loss of propeller control, accomplish the following:

(a) Within the next 25 hours time-in-service after the effective date of this AD, unless already accomplished within the last 25 hours time-in-service, and thereafter at intervals not to exceed 50 hours time-in-service from the last inspection, visually inspect the propeller governor arm with a 5-power magnifier for cracks and breaks in accordance with the following:

(1) For the Model S205 and S208 airplanes, with "Instructions" paragraph (a), steps 1 through 4, of SIAI-Marchetti Service Bulletin No. 205B43A dated September 16, 1977.

(2) For the Model F260 and F260B airplanes, with "Instructions" paragraph (a), steps 1 through 4, of SIAI-Marchetti Service Bulletin No. 260B18A dated September 16, 1977.

(b) If a crack or break is detected as a result of an inspection required by paragraph (a) of this AD, before further flight, replace the propeller governor arm with a serviceable part in accordance with the following:

(1) For the Model S205 and S208 airplanes with "Instructions" paragraph (c), steps 1 through 10, of the SIAI-Marchetti Service Bulletin No. 205B43A dated September 16, 1977.

(2) For the Model F260 and F260B airplanes with "Instructions" paragraph (c), steps 1 through 10, of SIAI-Marchetti Service Bulletin No. 260B18A dated September 16, 1977.

(c) When propeller governor arm, Part No. 260-13-274-01 is installed, the inspections in paragraph (a)of this AD are no longer required.

(d) Any equivalent means of complying with this AD must be approved by Manager, Aircraft Certification Staff, AEU-100, Europe, Africa, and Middle East Office, FAA, c/o American Embassy, Brussels, Belgium.

This AD supersedes AD 77-14-16, Amendment 39-2959.

This amendment becomes effective on May 9, 1983.

AD Assistant

Get AI-powered answers about this AD, check applicability, and find compliance steps.

Sign Up to Unlock
References
This information is not available.
--- - Part 39
FAA Documents