The FAA issued Emergency AD (EAD) 2002-08- 53, Docket No. 2002-SW-23-AD, on April 22, 2002, and superseding EAD 2002-09-51, Docket No. 2002-SW-24-AD, on May 9, 2002, for Bell Helicopter Textron, Inc. (Bell) Model 204B, 205A, A-1, and B helicopters. That EAD requires cleaning and inspecting T/R grip, part number (P/N) 204-011-728-019, with a magnet to determine if it is made of steel. If it is not made of steel, the current EAD requires replacing the T/R grip with an airworthy steel T/R grip. According to reports, T/R grips, P/N 204-011-728-019, removed from service on the Bell Model 204B and 205A-1 helicopters as required by AD 73-17-04 (38 FR 22223, August 17, 1973), were re-marked as P/N 205-011-711-101 and may have been installed on Bell Model 204 and 205 helicopters. These T/R grips may also be installed on similar restricted category military surplus helicopters.
On June 27, 2002, the FAA issued EAD 2002-13-51 for the specified model helicopters,which requires cleaning the T/R grip, determining if it is made of steel, and replacing the T/R grip with an airworthy T/R grip if the main body is not made of steel. That action was prompted by reports of timed-out T/R grips being improperly remarked and reinstalled on certain helicopters. This unsafe condition, if not detected, could result in failure of the T/R grip and subsequent loss of control of the helicopter.
This unsafe condition is likely to exist or develop on certain restricted category helicopters of these same type designs. Therefore, the FAA issued EAD 2002-13-51 to prevent failure of the T/R grip and subsequent loss of control of the helicopter. The AD requires cleaning the affected T/R grip, inspecting the T/R grip by placing a magnet on the exterior of the main body of the T/R grip to determine if the T/R grip is made of steel, and replacing any T/R grip not made of steel. The short compliance time involved is required because the previously described critical unsafe condition can adversely affect the structural integrity and controllability of the helicopter. Therefore, cleaning, inspecting, and determining if the T/R grip is made of steel and replacing any T/R grip not made of steel are required before further flight, and this AD must be issued immediately.
Since it was found that immediate corrective action was required, notice and opportunity for prior public comment thereon were impracticable and contrary to the public interest; and good cause existed to make the AD effective immediately by individual letters issued on June 27, 2002, to all known U.S. owners and operators of Model HH-1K, TH-1F, TH-1L, UH-1A, UH-1B, UH-1E, UH-1F, UH-1H, UH-1L, and UH-1P; and Southwest Florida Aviation SW204, SW204HP, SW205, and SW205A-1 helicopters manufactured by Bell for the Armed Forces of the United States. These conditions still exist, and the AD is hereby published in the Federal Register as an amendment to 14 CFR 39.13 to make it effective toall persons.
The FAA estimates that this AD will affect 75 helicopters of U.S. registry and will take approximately 2 work hours per helicopter to accomplish the required actions at an average labor rate of $60 per work hour. Required parts will cost approximately $4,864 per helicopter if the T/R is replaced. Based on these figures, the total cost impact of the AD on U.S. operators is estimated to be $373,800 assuming the T/ R is replaced on the entire fleet.
Comments Invited
Although this action is in the form of a final rule that involves requirements affecting flight safety and, thus, was not preceded by notice and an opportunity for public comment, comments are invited on this rule. Interested persons are invited to comment on this rule by submitting such written data, views, or arguments as they may desire. Communications should identify the Rules Docket number and be submitted in triplicate to the address specified under the caption ADDRESSES. All communications received on or before the closing date for comments will be considered, and this rule may be amended in light of the comments received. Factual information that supports the commenter's ideas and suggestions is extremely helpful in evaluating the effectiveness of the AD action and determining whether additional rulemaking action would be needed.
Comments are specifically invited on the overall regulatory, economic, environmental, and energy aspects of the rule that might suggest a need to modify the rule. All comments submitted will be available in the Rules Docket for examination by interested persons. A report that summarizes each FAA-public contact concerned with the substance of this AD will be filed in the Rules Docket.
Commenters wishing the FAA to acknowledge receipt of their mailed comments submitted in response to this rule must submit a self- addressed, stamped postcard on which the following statement is made: "Comments to Docket No. 2002-SW-21-AD." The postcard willbe date stamped and returned to the commenter.
The regulations adopted herein will not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government. Therefore, it is determined that this final rule does not have federalism implications under Executive Order 13132.
The FAA has determined that this regulation is an emergency regulation that must be issued immediately to correct an unsafe condition in aircraft, and that it is not a "significant regulatory action" under Executive Order 12866. It has been determined further that this action involves an emergency regulation under DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979). If it is determined that this emergency regulation otherwise would be significant under DOT Regulatory Policies and Procedures, a final regulatory evaluation will be prepared and placed inthe Rules Docket. A copy of it, if filed, may be obtained from the Rules Docket at the location provided under the caption ADDRESSES.
List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Safety.
Adoption of the Amendment
Accordingly, pursuant to the authority delegated to me by the Administrator, the Federal Aviation Administration amends part 39 of the Federal Aviation Regulations (14 CFR part 39) as follows:
PART 39--AIRWORTHINESS DIRECTIVES
1. The authority citation for part 39 continues to read as follows:
Authority: 49 U.S.C. 106(g), 40113, 44701.
Sec. 39.13 [Amended]
2. Section 39.13 is amended by adding a new airworthiness directive to read as follows: