2002-01-21 BAE Systems (Operations) Limited (Formerly British Aerospace Regional Aircraft): Amendment 39-12615. Docket 2001-NM- 199-AD.
Applicability: Model BA-146 series airplanes and Avro 146-RJ series airplanes, certificated in any category, having BAE Modification HCM01059A (installation of a standby generator and control system manufactured by Vickers) embodied.
Note 1: This AD applies to each airplane identified in the preceding applicability provision, regardless of whether it has been modified, altered, or repaired in the area subject to the requirements of this AD. For airplanes that have been modified, altered, or repaired so that the performance of the requirements of this AD is affected, the owner/operator must request approval for an alternative method of compliance in accordance with paragraph (b) of this AD. The request should include an assessment of the effect of the modification, alteration, or repair on the unsafe condition addressed by this AD; and, ifthe unsafe condition has not been eliminated, the request should include specific proposed actions to address it.
Compliance: Required as indicated, unless accomplished previously.
To prevent loss of the standby generator, which, in the event of an emergency involving the principal generator, could result in the loss of electrical power to the airplane; accomplish the following:
Replacement
(a) Within 43 months after the effective date of this AD: Replace the Vickers standby generator having part number (P/N) 520829 with a new, improved Vickers standby generator having P/N 3022049-000, in accordance with BAE Systems (Operations) Limited Modification Service Bulletin SB.24-137-01691A, dated April 12, 2001.
Alternative Methods of Compliance
(b) An alternative method of compliance or adjustment of the compliance time that provides an acceptable level of safety may be used if approved by the Manager, International Branch, ANM-116, Transport Airplane Directorate, FAA. Operators shall submit their requests through an appropriate FAA Principal Maintenance Inspector, who may add comments and then send it to the Manager, International Branch, ANM-116.
Note 2: Information concerning the existence of approved alternative methods of compliance with this AD, if any, may be obtained from the International Branch, ANM-116.
Special Flight Permits
(c) Special flight permits may be issued in accordance with sections 21.197 and 21.199 of the Federal Aviation Regulations (14 CFR 21.197 and 21.199) to operate the airplane to a location where the requirements of this AD can be accomplished.
Incorporation by Reference
(d) The actions shall be done in accordance with BAE Systems (Operations) Limited Modification Service Bulletin SB.24-137-01691A, dated April 12, 2001. This incorporation by reference was approved by the Director of the Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR part 51. Copies may be obtained from British Aerospace Regional Aircraft American Support, 13850 Mclearen Road, Herndon, Virginia 20171. Copies may be inspected at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington; or at the Office of the Federal Register, 800 North Capitol Street, NW., suite 700, Washington, DC.
Note 3: The subject of this AD is addressed in British airworthiness directive 004-04-2001, dated May 22, 2001.
Effective Date
(e) This amendment becomes effective on March 6, 2002.