A proposal to amend part 39 of the Federal Aviation Regulations (14 CFR part 39) to include an airworthiness directive (AD) that is applicable to certain Model 737-100, -200, -300, -400, and -500 series airplanes; and Model 747, 757, 767, and 777 series airplanes; was published in the Federal Register on April 20, 2001 (66 FR 20218). That action proposed to require replacing the rudder pedal pushrod fasteners for both the captain's and first officer's pedal assemblies with new, improved fasteners. \n\nComments \n\n\tInterested persons have been afforded an opportunity to participate in the making of this amendment. Due consideration has been given to the comments received. \n\n\tOne commenter supports the proposed rule; a second commenter states that it has no technical objection and intends to accomplish the proposed actions; and a third commenter states no objection to the proposed rule. \n\nRefer to Additional Sources of Service Information \n\n\tTwo commenters request that the FAA revise Table 2 of the proposed AD to refer to Boeing Service Bulletin 767-27A0159, Revision 1, dated April 5, 2001, as an acceptable source of service information for the actions in paragraph (a) of the proposed AD. (The proposed AD refers to the original issue of Boeing Alert Service Bulletin 767-27A0159, dated June 10, 1999, as an acceptable source of service information for accomplishment of the actions in paragraph (a) of the proposed rule on affected Model 767 series airplanes.) One of the commenters also requests that we add a new note similar to Note 2 to cover incorporation of Boeing Service Bulletin 767-27A0159, Revision 1, as acceptable for compliance with the proposed AD. \n\n\tWe concur with the commenters' request to reference Boeing Service Bulletin 767-27A0159, Revision 1, in Table 2 of this AD and have revised Table 2 accordingly. Since we are making this change, we find that there is no need to add a new note similar to Note 2 of this AD to the final rule as one of the commenters suggested. \n\n\tOne commenter also asks us to revise Table 1 under the applicability statement of the proposed AD to refer to Boeing Alert Service Bulletin 737-27A1214, dated April 8, 1999, and Boeing Service Bulletin 767-27A0159, Revision 1. (Table 1 of the proposed AD lists Boeing Service Bulletin 737-27A1214, Revision 1, dated July 1, 1999, as the applicable service bulletin listing affected Model 737-100, -200, -300, -400, and -500 series airplanes; and the original issue of Boeing Alert Service Bulletin 767-27A0159, as the applicable service bulletin listing affected Model 767 series airplanes.) The same commenter also asks that we revise Table 2 of the proposed AD to refer to Boeing Alert Service Bulletin 737-27A1214, dated April 8, 1999. The commenter's rationale for these requests is that these service bulletins provide for the incorporation of the improved fasteners and compliance with the proposed action. \n\n\tWe do not concur that any change is necessary. Comparison of the effectivity listings of the original issue and Revision 1 of Boeing Service Bulletins 737-27A1214 and 767-27A0159 show that both issues of these service bulletins list the same affected airplane line numbers. Thus, we find that revising Table 1 as the commenter suggests would add no value and may be confusing for operators. No change to the final rule is necessary in this regard. \n\n\tIn addition, because Note 2 of this AD already states that the original issue of Boeing Alert Service Bulletin 737-27A1214 is acceptable for compliance with the applicable action in this AD, we find no need to also list that service bulletin in Table 2 of this AD. No change to this final rule is necessary in this regard. \n\nIssue Action as a Supersedure of AD 98-13-12 R1 \n\n\tOne commenter suggests that the proposed AD should supersede AD 98-13-12 R1, amendment 39-10930 (63 FR 68165, December 10, 1998). The commenter states that the proposed actions in this AD remove theunsafe condition addressed by AD 98-13-12 R1. The commenter also notes that operators cannot comply with both AD 98-13-12 R1 and the proposed AD because this proposed AD requires rudder pedal pushrod fasteners to be torqued at a lower value than that required by AD 98-13-12 R1. The commenter is concerned that operators will need to request alternative methods of compliance for both of these ADs. \n\n\tWe do not concur with the request to supersede AD 98-13-12 R1. That AD requires a one-time inspection to detect discrepancies of the fasteners that connect the pushrods to the rudder pedal assemblies, and corrective actions, if necessary, on certain Boeing Model 737, 747, 757, 767, and 777 series airplanes. The actions in that AD are intended to prevent loss of rudder control, jamming of the rudder system, uncommanded movement of the rudder system, and consequent reduced controllability of the airplane. Corrective actions in that AD include tightening nuts and bolts to specified torque limits, installing missing fasteners, and replacing incorrectly installed fasteners with new fasteners, as applicable. This new AD requires replacement of existing rudder pedal pushrod fasteners for both the captain's and first officer's pedal assemblies with new, improved fasteners that use self-locking, castellated nuts and cotter pins through the bolts for nut retention. We consider the actions in this AD to provide an improved level of safety over that provided by the actions in AD 98-13-12 R1. \n\n\tSince the compliance time for the actions required by AD 98-13-12 R1 (90 days after July 6, 1998, which is the effective date of AD 98-13-12, amendment 39-10600 (63 FR 33246, June 17, 1998)) has passed, most airplanes should already be in compliance with that AD. However, we find that accomplishment of the requirements of that AD is necessary in the event that an affected airplane is added to the U.S. Register. In that event, we find that accomplishment of paragraph (a) of this AD beforethe airplane is added to the U.S. Register is acceptable for compliance with AD 98-13-12 R1. We have added a new paragraph (b) to this AD (and reordered subsequent paragraphs) accordingly. \n\n\tWith regard to the commenter's perceived need for operators to apply for an alternative method of compliance, we note that, once the new, improved fasteners are installed according to this AD, the torque requirements for the old fasteners referenced in AD 98-13-12 R1 no longer apply. Further, the actions in this AD are not considered "terminating action" for AD 98-13-12 R1 because that AD did not contain any repetitive actions to terminate. No change to this final rule is necessary in this regard. \n\nExtend Compliance Time \n\n\tOne commenter requests that we extend the compliance time for the proposed requirements from 18 to 36 months after the effective date of this AD. The commenter's rationale is that there have been very few reports of disconnection of the rudder pedal pushrod from the rudder pedal assembly, and all affected airplanes have previously been inspected per AD 98-13-12 R1. \n\n\tWe do not concur. In developing an appropriate compliance time for this AD, we considered the manufacturer's recommendation, as well as the degree of urgency associated with addressing the subject unsafe condition, the average utilization of the affected fleet, and the small amount of time necessary to perform the inspection (one hour). We have also considered that the service bulletins have been available for some time, and many operators have already accomplished the required actions. In light of all of these factors, the FAA finds an 18-month compliance time for completing the required actions to be warranted, in that it represents an appropriate interval of time wherein airplanes will be able to continue to operate without compromising safety, and the majority of operators will be able to do the required work during a scheduled maintenance visit. No change to the final rule is necessary in this regard. \n\nRevise Cost Impact Estimate \n\n\tOne commenter requests that the FAA revise the proposed rule to increase the cost estimate. The commenter states that it has compiled its own cost estimate for this inspection, based on actual direct costs incurred, and estimates the costs associated with the proposed AD as $125.76 for labor and $226.00 for materials per airplane, for a total of $351.76 per airplane. \n\n\tWe do not concur with the request. With regard to the number of work hours necessary to accomplish the actions in this AD, the cost impact information describes only the "direct" costs of the specific actions required by this AD. The number of work hours necessary to accomplish the required actions, specified as 1 work hour in the cost impact information below, was provided to the FAA by the manufacturer based on the best data available to date. This number represents the time necessary to perform only the actions actually required by this AD. The FAA recognizes that, in accomplishing the requirements of any AD, operators may incur "incidental" costs in addition to the "direct" costs. The cost analysis in AD rulemaking actions, however, typically does not include incidental costs, such as the time required to gain access and close up, planning time, or time necessitated by other administrative actions. Because incidental costs may vary significantly from operator to operator, they are almost impossible to calculate. \n\n\tWith regard to the cost of materials, the cost of parts necessary to accomplish the required actions, specified as approximately $75 in the cost impact information below, was provided to the FAA by the manufacturer based on the best data available to date. The commenter did not specify what materials its cost estimate included, so it is impossible for the FAA to know the reason for the difference between our cost estimate and the commenter's. No change to the final rule is necessary in this regard. \n\nConclusion \n\n\tAftercareful review of the available data, including the comments noted above, the FAA has determined that air safety and the public interest require the adoption of the rule with the changes previously described. The FAA has determined that these changes will neither increase the economic burden on any operator nor increase the scope of the AD. \n\nCost Impact \n\n\tThere are approximately 6,097 Model 737-100, -200, -300, -400, and -500 series airplanes; and Model 747, 757, 767, and 777 series airplanes; of the affected design in the worldwide fleet. The FAA estimates that 2,338 airplanes of U.S. registry will be affected by this AD, that it will take approximately 1 work hour per airplane to accomplish the required actions, and that the average labor rate is $60 per work hour. Required parts will cost approximately $75 per airplane. Based on these figures, the cost impact of this AD on U.S. operators is estimated to be $315,630, or $135 per airplane. \n\n\tThe cost impact figure discussedabove is based on assumptions that no operator has yet accomplished any of the requirements of this AD action, and that no operator would accomplish those actions in the future if this AD were not adopted. The cost impact figures discussed in AD rulemaking actions represent only the time necessary to perform the specific actions actually required by the AD. These figures typically do not include incidental costs, such as the time required to gain access and close up, planning time, or time necessitated by other administrative actions. \n\nRegulatory Impact \n\n\tThe regulations adopted herein will not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government. Therefore, it is determined that this final rule does not have federalism implications under Executive Order 13132. \n\n\tFor the reasons discussed above, I certify that this action (1) is not a "significant regulatory action" under Executive Order 12866; (2) is not a "significant rule" under DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and (3) will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act. A final evaluation has been prepared for this action and it is contained in the Rules Docket. A copy of it may be obtained from the Rules Docket at the location provided under the caption ADDRESSES. \n\nList of Subjects in 14 CFR Part 39 \n\n\tAir transportation, Aircraft, Aviation safety, Incorporation by reference, Safety. \n\nAdoption of the Amendment \n\n\tAccordingly, pursuant to the authority delegated to me by the Administrator, the Federal Aviation Administration amends part 39 of the Federal Aviation Regulations (14 CFR part 39) as follows: \n\nPART 39--AIRWORTHINESS DIRECTIVES \n\n\t1. The authority citation for part 39 continues to read as follows: \n\n\tAuthority: 49 U.S.C. 106(g), 40113, 44701. \n\nSec. 39.13 (Amended) \n\n\t2. Section 39.13 is amended by adding the following new airworthiness directive: