AD 2000-23-15

This amendment adopts a new airworthiness directive (AD), applicable to certain Saab Model SAAB SF340A and SAAB 340B series airplanes, that requires inspecting the connector on the refuel/defuel panel and the electrical connector on the illuminated placard to detect signs of fluid ingression or corrosion, and corrective actions. The actions specified by this AD are intended to prevent electrical shorts or arcing at the illuminated placard connector at the refuel/defuel panel, which could result in a potential ignition source for fuel vapors during fueling procedures. This action is intended to address the identified unsafe condition.

Final rule

2000-23-15 SAAB AIRCRAFT AB: Amendment 39-11987. Docket 2000-NM-213-AD.
Applicability: Model SAAB SF340A series airplanes, serial numbers -004 through -159 inclusive; and Model SAAB 340B series airplanes, serial numbers -160 through -459 inclusive; certificated in any category; on which a refuel/defuel panel having part number 7239160-505 is installed.

NOTE 1: This AD applies to each airplane identified in the preceding applicability provision, regardless of whether it has been modified, altered, or repaired in the area subject to the requirements of this AD. For airplanes that have been modified, altered, or repaired so that the performance of the requirements of this AD is affected, the owner/operator must request approval for an alternative method of compliance in accordance with paragraph (b) of this AD. The request should include an assessment of the effect of the modification, alteration, or repair on the unsafe condition addressed by this AD; and, if the unsafecondition has not been eliminated, the request should include specific proposed actions to address it.

Compliance: Required as indicated, unless accomplished previously.

To prevent electrical shorts or arcing at the illuminated panel connector at the refuel/defuel panel, which could result in a potential ignition source for fuel vapors during fueling procedures, accomplish the following:

Inspection and Corrective Actions
(a) Within 6 months after the effective date of this AD, inspect the electrical connector on the refuel/defuel panel and the electrical connector on the illuminated placard to detect signs of fluid ingression or corrosion; and accomplish applicable corrective actions (including a sealing procedure, a cleaning/sealing procedure, and repair of corrosion on the refuel/defuel panel mounting plate); in accordance with Saab Service Bulletin 340-28-022, dated February 25, 2000.

Alternative Methods of Compliance
(b) An alternative method of compliance or adjustment of the compliance time that provides an acceptable level of safety may be used if approved by the Manager, International Branch, ANM-116, FAA, Transport Airplane Directorate. Operators shall submit their requests through an appropriate FAA Principal Maintenance Inspector, who may add comments and then send it to the Manager, International Branch, ANM-116.

NOTE 2: Information concerning the existence of approved alternative methods of compliance with this AD, if any, may be obtained from the International Branch, ANM-116.

Special Flight Permits
(c) Special flight permits may be issued in accordance with sections 21.197 and 21.199 of the Federal Aviation Regulations (14 CFR 21.197 and 21.199) to operate the airplane to a location where the requirements of this AD can be accomplished.

Incorporation by Reference
(d) The actions shall be done in accordance with Saab Service Bulletin 340-28-022, dated February 25, 2000. This incorporation by referencewas approved by the Director of the Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR part 51. Copies may be obtained from Saab Aircraft AB, SAAB Aircraft Product Support, S-581.88, Linkoping, Sweden. Copies may be inspected at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington; or at the Office of the Federal Register, 800 North Capitol Street, NW., suite 700, Washington, DC.

NOTE 3: The subject of this AD is addressed in Swedish airworthiness directive 1-156, dated February 28, 2000.

Effective Date
(e) This amendment becomes effective on December 27, 2000.

A proposal to amend part 39 of the Federal Aviation Regulations (14 CFR part 39) to include an airworthiness directive (AD) that is applicable to certain Saab Model SAAB SF340A and SAAB 340B series airplanes was published in the Federal Register on September 19, 2000 (65 FR 56507). That action proposed to require inspecting the connector on the refuel/defuel panel and the electrical connector on the illuminated placard to detect signs of fluid ingression or corrosion, and corrective actions.

Comments
Interested persons have been afforded an opportunity to participate in the making of this amendment. No comments were submitted in response to the proposal or the FAA's determination of the cost to the public.

Conclusion
The FAA has determined that air safety and the public interest require the adoption of the rule as proposed.

Cost Impact
The FAA estimates that 289 Model SAAB SF340A and SAAB 340B series airplanes of U.S. registry will be affected by this AD, that it will take approximately 4 work hours per airplane to accomplish the required actions, and that the average labor rate is $60 per work hour. Based on these figures, the cost impact of the AD on U.S. operators is estimated to be $69,360, or $240 per airplane.

The cost impact figure discussed above is based on assumptions that no operator has yet accomplished any of the requirements of this AD action, and that no operator would accomplish those actions in the future if this AD were not adopted. The cost impact figures discussed in AD rulemaking actions represent only the time necessary to perform the specific actions actually required by the AD. These figures typically do not include incidental costs, such as the time required to gain access and close up, planning time, or time necessitated by other administrative actions.

Regulatory Impact
The regulations adopted herein will not have a substantial direct effect on the States, on the relationshipbetween the national Government and the States, or on the distribution of power and responsibilities among the various levels of government. Therefore, it is determined that this final rule does not have federalism implications under Executive Order 13132.

For the reasons discussed above, I certify that this action (1) is not a "significant regulatory action" under Executive Order 12866; (2) is not a "significant rule" under DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and (3) will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act. A final evaluation has been prepared for this action and it is contained in the Rules Docket. A copy of it may be obtained from the Rules Docket at the location provided under the caption "ADDRESSES."

List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety.

Adoption of the Amendment
Accordingly, pursuant to the authority delegated to me by the Administrator, the Federal Aviation Administration amends part 39 of the Federal Aviation Regulations (14 CFR part 39) as follows:

PART 39 - AIRWORTHINESS DIRECTIVES
1. The authority citation for part 39 continues to read as follows: Authority: 49 U.S.C. 106(g), 40113, 44701.

39.13 [Amended]
2. Section 39.13 is amended by adding the following new airworthiness directive: