2000-09-01 R1 MCDONNELL DOUGLAS: Amendment 39-11809. Docket 99-NM-338-AD. Supersedes AD 93-20-02, Amendment 39-8709.\n\n\tApplicability: Model DC-8 series airplanes that have been converted from a passenger to a cargo-carrying ("freighter") configuration in accordance with Supplemental Type Certificate (STC) SA1802SO or SA421NW; certificated in any category. \n\n\tNOTE 1: This AD applies to each airplane identified in the preceding applicability provision, regardless of whether it has been otherwise modified, altered, or repaired in the area subject to the requirements of this AD. For airplanes that have been modified, altered, or repaired so that the performance of the requirements of this AD is affected, the owner/operator must request approval for an alternative method of compliance in accordance with paragraph (g)(1) of this AD. The request should include an assessment of the effect of the modification, alteration, or repair on the unsafe condition addressed by this AD; and, if the unsafe condition has not been eliminated, the request should include specific proposed actions to address it. \n\n\tCompliance: Required as indicated, unless accomplished previously. \n\n\tTo prevent opening of the cargo door while the airplane is in flight, and consequent rapid decompression of the airplane including possible loss of the door, flight control, or severe structural damage, accomplish the following: \n\nRESTATEMENT OF REQUIREMENTS OF AD 93-20-02\nActions Addressing the Main Deck Cargo Door\n\t(a)\tWithin 7 days after January 21, 1992 (the effective date of AD 92-02-05, amendment 39-8141), and thereafter at intervals not to exceed 100 hours time-in-service, perform the following inspections:\n\n\t\t(1)\tInspect the cargo door wire bundle between the exit point of the cargo liner and the attachment point on the cargo door to detect crimped, frayed, or chafed wires; and inspect for damaged, loose, or missing hardware mounting components. Prior to further flight, repairany damaged wiring or hardware mounting components in accordance with FAA-approved maintenance procedures.\n\n\t\t(2)\tInspect the cargo door latch rollers in the lower sill of the cargo door opening of the airplane to ensure that all twelve rollers can be freely rotated by hand. Prior to further flight, replace any discrepant roller components found, and repair any rollers that cannot be rotated freely by hand, in accordance with FAA-approved maintenance procedures.\n\n\t(b)\tWithin 7 days after November 17, 1993 (the effective date of AD 93-20-02, amendment 39-8709), revise the Limitations Section of the appropriate FAA-approved Airplane Flight Manual Supplement (AFMS) by replacing item 5 in the AFMS for SA1802SO, and item 6 in the AFMS for SA421NW, with the following. (This may be accomplished by inserting a copy of this AD into the AFMS.)\n\n"Prior to initiating the cargo door closing sequence, a flight crew member must verify that the cargo door warning light is illuminated. Afterthe door closing sequence is complete, and visual verification has been made that the latches are closed and the lockpins are properly engaged, a flight crew member must verify that the cargo door warning light is extinguished, and then conduct a PRESS-TO-TEST of the warning light to ensure that the light is operational. Pull the cargo door circuit breakers labeled ?pump' and ?valve' prior to takeoff. Methods for documentation of compliance with the preceding procedures must be approved by the FAA Principal Maintenance Inspector (PMI)."\n\nNEW REQUIREMENTS OF THIS AD\nActions Addressing the Main Deck Cargo Door Powered Lock Systems\n\t(c)\tExcept as provided by paragraph (f) of this AD, within 30 days after the effective date of this AD, unless previously accomplished within the last 18 months prior to the effective date of this AD, replace the circuit breakers of the main deck cargo door labeled "pump" and "valve" with new circuit breakers.\n\nActions Addressing the Main Deck Cargo Door Hydraulic Systems\n\t(d)\tWithin 18 months after the effective date of this AD, modify the mechanical and hydraulic systems of the main deck cargo door, in accordance with National Aircraft Service, Inc. (NASI) Service Bulletin SB-99-01, Revision A, dated October 15, 1999. \n\nActions Addressing the Main Deck Cargo Door Indication System\n\t(e)\tWithin 18 months after the effective date of this AD, modify the indication system of the main deck cargo door to indicate to the pilots whether the main deck cargo door is closed, latched, and locked; install a means to visually inspect the locking mechanism of the main deck cargo door; install a means to remove power to the door while the airplane is in flight; and install a means to prevent pressurization to an unsafe level if the main deck cargo door is not closed, latched, and locked; in accordance with a method approved by the Manager, Los Angeles Aircraft Certification Office (ACO), FAA, Transport Airplane Directorate.\n\n\tNOTE 2: Installation of NASI Vent Door System STC ST01116CH, is an approved means of compliance with the requirements of paragraph (e) of this AD.\n\n\t(f)\tCompliance with both paragraphs (d) and (e) of this AD constitutes terminating action for the requirements of both paragraphs (a) and (b) of this AD, and the AFMS revision required by paragraph (b) of this AD may be removed. Compliance with paragraph (e) of this AD within 30 days after the effective date of this AD eliminates the requirement to comply with paragraph (c) of this AD.\n\nAlternative Methods of Compliance\n\t(g)\t(1)\tAn alternative method of compliance or adjustment of the compliance time that provides an acceptable level of safety may be used if approved by the Manager, Los Angeles Aircraft Certification Office (ACO), FAA, Transport Airplane Directorate. Operators shall submit their requests through an appropriate FAA PMI, who may add comments and then send it to the Manager, Los Angeles ACO.\n\n\tNOTE 3: Information concerning theexistence of approved alternative methods of compliance with this AD, if any, may be obtained from the Los Angeles ACO.\n\n\t\t(2)\tAlternative methods of compliance to paragraph (a) of AD 93-20-02, amendment 39-8709, approved previously in accordance with that AD, are approved as alternative methods of compliance with only paragraph (b) of this AD.\n\n\t\t(3)\tAlternative methods of compliance to paragraph (b) of AD 93-20-02, amendment 39-8709, approved previously in accordance with that AD, are approved as alternative methods of compliance with only paragraph (a) of this AD. \n\nSpecial Flight Permits\n\t(h)\tSpecial flight permits may be issued in accordance with sections 21.197 and 21.199 of the Federal Aviation Regulations (14 CFR 21.197 and 21.199) to operate the airplane to a location where the requirements of this AD can be accomplished. \n\nIncorporation by Reference\n\t(i)\tThe modification required by paragraph (d) of this AD shall be done in accordance with National Aircraft Service, Inc. (NASI) Service Bulletin SB-99-01, Revision A, dated October 15, 1999. This incorporation by reference was approved previously by the Director of the Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR part 51 as of June 7, 2000 (65 FR 25627, May 3, 2000). Copies may be obtained from National Aircraft Service, Inc. (NASI), 9133 Tecumseh-Clinton Road, Tecumseh, MI 49286.Copies may be inspected at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington; or at the FAA, Transport Airplane Directorate, Los Angeles Aircraft Certification Office, 3960 Paramount Boulevard, Lakewood, California; or at the Office of the Federal Register, 800 North Capitol Street, NW., suite 700, Washington, DC.\n\nEffective Date\n\t(j)\tThe effective date of this amendment remains June 7, 2000.\n\nAPPENDIX 1\nExcerpt from an FAA Memorandum to Director-Airworthiness and Technical Standards of ATA, dated March 20, 1992\n\n"(1)\tIndication System:\n\t(a)\tThe indication system must monitor the closed, latched, and locked positions, directly.\n\n\t(b)\tThe indicator should be amber unless it concerns an outward opening door whose opening during takeoff could present an immediate hazard to the airplane. In that case the indicator must be red and located in plain view in front of the pilots. An aural warning is also advisable. A display on the master caution/warning system is also acceptable as an indicator. For the purpose of complying with this paragraph, an immediate hazard is defined as significant reduction in controllability, structural damage, or impact with other structures, engines, or controls.\n\n\t(c)\tLoss of indication or a false indication of a closed, latched, and locked condition must be improbable.\n\n\t(d)\tA warning indication must be provided at the door operators station that monitors the door latched and locked conditions directly, unless the operator has a visual indication that the door is fully closed and locked. For example, a ventdoor that monitors the door locks and can be seen from the operators station would meet this requirement.\n\n(2)\tMeans to Visually Inspect the Locking Mechanism:\n\tThere must be a visual means of directly inspecting the locks. Where all locks are tied to a common lock shaft, a means of inspecting the locks at each end may be sufficient to meet this requirement provided no failure condition in the lock shaft would go undetected when viewing the end locks. Viewing latches may be used as an alternate to viewing locks on some installations where there are other compensating features.\n\n(3)\tMeans to Prevent Pressurization:\n\tAll doors must have provisions to prevent initiation of pressurization of the airplane to an unsafe level, if the door is not fully closed, latched and locked.\n\n(4)\tLock Strength:\n\tLocks must be designed to withstand the maximum output power of the actuators and maximum expected manual operating forces treated as a limit load. Under these conditions, the door must remain closed, latched and locked.\n\n(5)\tPower Availability:\n\tAll power to the door must be removed in flight and it must not be possible for the flight crew to restore power to the door while in flight.\n\n(6)\tPowered Lock Systems:\n\tFor doors that have powered lock systems, it must be shown by safety analysis that inadvertent opening of the door after it is fully closed, latched and locked, is extremely improbable."