This amendment was prompted by an accident, which occurred in November 1996, and an incident, which occurred in August 1997, involving Model AS-350B2 helicopters offshore over the Gulf of Mexico. The DGAC, although notified by the FAA of both the accident and incident, has not issued an AD on this subject. There were two other unconfirmed incidents cited by the National Transportation Safety Board (based on manufacturer's reports) involving the same control rod, part number (P/N) 350A33-2145-01.
These helicopter models are manufactured in France and are type certificated for operation in the United States under the provisions of section 21.29 of the Federal Aviation Regulations (14 CFR 21.29) and the applicable bilateral airworthiness agreement. The FAA has determined that AD action is necessary for products of this type design certified for operation in the United States.
Since an unsafe condition has been identified that is likely to existor develop on other Eurocopter France Model AS-350B, B1, B2, BA, C, D, D1, and AS 355E, F, F1, F2, and N helicopters of the same type design registered in the United States, this AD is being issued to prevent separation of the outboard spherical bearing ball from its outer race, rubbing of the body of the control rod against the tail rotor blade pitch horn clevis, failure of the control rod, and loss of control of the helicopter. The short compliance time involved is required because the previously described critical unsafe condition can adversely affect the controllability of the helicopter. Therefore, measuring the control rod outboard spherical bearing radial and axial play is required within 50 hours time-in-service, and this AD must be issued immediately.
Since a situation exists that requires the immediate adoption of this regulation, it is found that notice and opportunity for prior public comment hereon are impracticable, and that good cause exists for making this amendment effective in less than 30 days.
Cost Impact
The FAA estimates that 507 helicopters will be affected by this AD, that it will take approximately 1 work hour, and that the average labor rate is $60 per work hour. Required parts will cost approximately $2,376 per helicopter. Based on these figures, the total cost impact of this AD on U.S. operators is estimated to be $1,235,052 to perform the measurement and to replace both control rods on each helicopter in the fleet.
Comments Invited
Although this action is in the form of a final rule that involves requirements affecting flight safety and, thus, was not preceded by notice and an opportunity for public comment, comments are invited on this rule. Interested persons are invited to comment on this rule by submitting such written data, views, or arguments as they may desire. Communications should identify the Rules Docket number and be submitted in triplicate to the address specified under the caption "ADDRESSES." All communications received on or before the closing date for comments will be considered, and this rule may be amended in light of the comments received. Factual information that supports the commenter's ideas and suggestions is extremely helpful in evaluating the effectiveness of the AD action and determining whether additional rulemaking action would be needed.
Comments are specifically invited on the overall regulatory, economic, environmental, and energy aspects of the rule that might suggest a need to modify the rule. All comments submitted will be available, both before and after the closing date for comments, in the Rules Docket for examination by interested persons. A report that summarizes each FAA-public contact concerned with the substance of this AD will be filed in the Rules Docket.
Commenters wishing the FAA to acknowledge receipt of their comments submitted in response to this rule must submit a self-addressed, stamped postcard on which the following statement is made: "Comments to Docket No. 98-SW-41-AD." The postcard will be date stamped and returned to the commenter.
Regulatory Impact
The regulations adopted herein will not have substantial direct effects on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government. Therefore, in accordance with Executive Order 12612, it is determined that this final rule does not have sufficient federalism implications to warrant the preparation of a Federalism Assessment.
The FAA has determined that this regulation is an emergency regulation that must be issued immediately to correct an unsafe condition in aircraft, and that it is not a "significant regulatory action" under Executive Order 12866. It has been determined further that this action involves an emergency regulation under DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979). If it is determined that this emergency regulation otherwise would be significant under DOT Regulatory Policies and Procedures, a final regulatory evaluation will be prepared and placed in the Rules Docket. A copy of it, if filed, may be obtained from the Rules Docket at the location provided under the caption "ADDRESSES."
List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Safety.
Adoption of the Amendment
Accordingly, pursuant to the authority delegated to me by the Administrator, the Federal Aviation Administration amends part 39 of the Federal Aviation Regulations (14 CFR part 39) as follows:
PART 39 - AIRWORTHINESS DIRECTIVES
1. The authority citation for part 39 continues to read as follows:
Authority: 49 U.S.C. 106(g), 40113, 44701.
39.13 [Amended]
2. Section 39.13 is amended by adding a new airworthiness directive to read as follows: