98-13-13 MITSUBISHI HEAVY INDUSTRIES, LTD. [Formerly Nihon Aeroplane Manufacturing Company (NMAC)]: Amendment 39-10601. Docket 97-NM-71-AD.
Applicability: All Model YS-11 and YS-11A -200, -300, -500, and -600 series airplanes; certificated in any category.
NOTE 1: This AD applies to each airplane identified in the preceding applicability provision, regardless of whether it has been modified, altered, or repaired in the area subject to the requirements of this AD. For airplanes that have been modified, altered, or repaired so that the performance of the requirements of this AD is affected, the owner/operator must request approval for an alternative method of compliance in accordance with paragraph (b) of this AD. The request should include an assessment of the effect of the modification, alteration, or repair on the unsafe condition addressed by this AD; and, if the unsafe condition has not been eliminated, the request should include specific proposed actions to addressit.
Compliance: Required as indicated, unless accomplished previously.
To prevent loss of airplane controllability or engine overspeed with consequent loss of engine power caused by the power levers being positioned below the flight idle stop while the airplane is in flight, accomplish the following:
(a) Within 30 days after the effective date of this AD, revise the Limitations Section of the FAA-approved Airplane Flight Manual (AFM) to include the following statements. This action may be accomplished by inserting a copy of this AD into the AFM.
"Warning: While the airplane is airborne, the LOW STOP lever (flight fine pitch stop)
should not be placed in the GROUND position for any reason. Placing the LOW STOP
lever in the GROUND position in flight may lead to loss of airplane control or may result in an engine overspeed condition and consequent loss of engine power."
(b) An alternative method of compliance or adjustment of the compliance time thatprovides an acceptable level of safety may be used if approved by the Manager, Standardization Branch, ANM-113, FAA, Transport Airplane Directorate. Operators shall submit their requests through an appropriate FAA Principal Operations Inspector, who may add comments and then send it to the Manager, Standardization Branch, ANM-113.
NOTE 2: Information concerning the existence of approved alternative methods of compliance with this AD, if any, may be obtained from the Standardization Branch, ANM-113.
(c) Special flight permits may be issued in accordance with sections 21.197 and 21.199 of the Federal Aviation Regulations (14 CFR 21.197 and 21.199) to operate the airplane to a location where the requirements of this AD can be accomplished.
(d) This amendment becomes effective on July 23, 1998.
FOR FURTHER INFORMATION CONTACT: Mark Quam, Aerospace Engineer, Standardization Branch, ANM-113, FAA, Transport Airplane Directorate, 1601 Lind Avenue SW., Renton, Washington 98055-4056; telephone (425) 227-2145; fax (425) 227-1149.