The Direction G n rale de l'Aviation Civile (DGAC), which is the airworthiness authority for France, notified the FAA that an unsafe condition may exist on certain Aerospatiale Model ATR42-500 series airplanes. The DGAC advises that interference between the lower fairing of the rudder horn and the vertical stabilizer has been found on an in-service airplane. Because this condition has been traced to quality control problems that occurred during manufacture, similar interference may exist on other airplanes of this type. Such interference, if not detected and corrected, could cause the rudder to jam, which could result in reduced controllability of the airplane.
Explanation of Relevant Service Information
Aerospatiale has issued Service Bulletin ATR42-55-0007, dated November 13, 1997, which describes procedures for performing a one-time visual inspection to measure whether the gap between the lower fairing of the rudder horn and the vertical stabilizer is within certain specified limits. Accomplishment of the actions specified in the service bulletin is intended to adequately address the identified unsafe condition. The DGAC classified this service bulletin as mandatory and issued French airworthiness directive 97-328-072(B)R1, dated November 19, 1997, in order to assure the continued airworthiness of these airplanes in France.
FAA's Conclusions
This airplane model is manufactured in France and is type certificated for operation in the United States under the provisions of section 21.29 of the Federal Aviation Regulations (14 CFR 21.19) and the applicable bilateral airworthiness agreement. Pursuant to this bilateral airworthiness agreement, the DGAC has kept the FAA informed of the situation described above. The FAA has examined the findings of the DGAC, reviewed all available information, and determined that AD action is necessary for products of this type design that are certificated for operation in the United States.Explanation of Requirements of the Rule
Since an unsafe condition has been identified that is likely to exist or develop on other airplanes of the same type design registered in the United States, this AD is being issued to prevent interference between the rudder horn and the vertical stabilizer, which could cause the rudder to jam, consequent reduced controllability of the airplane. This AD requires accomplishment of the actions specified in the service bulletin described previously, except as discussed below.
Differences Between the AD and Service Bulletin
Operators should note that, although the service bulletin specifies that the manufacturer may be contacted for disposition of inspection results that are outside certain specified limits, this AD requires the repair of such conditions to be accomplished in accordance with a method approved by the FAA.
In addition, unlike the procedure described in the service bulletin, this AD would not permit further flight on aninterim basis following removal of the rudder fairing. The FAA has determined that, because of the safety implications and possible aerodynamic or airplane performance consequences associated with flight with the rudder fairing removed, any gap between the lower fairing of the rudder horn and the vertical stabilizer that is outside the specified limits must be repaired or modified prior to further flight, in accordance with a method approved by the FAA.
Cost Impact
None of the airplanes affected by this action are on the U.S. Register. All airplanes included in the applicability of this rule currently are operated by non-U.S. operators under foreign registry; therefore, they are not directly affected by this AD action. However, the FAA considers that this rule is necessary to ensure that the unsafe condition is addressed in the event that any of these subject airplanes are imported and placed on the U.S. Register in the future.
Should an affected airplane be imported andplaced on the U.S. Register in the future, it would require approximately 5 work hours to accomplish the required actions, at an average labor rate of $60 per work hour. Based on these figures, the cost impact of this AD would be $300 per airplane.
Determination of Rule's Effective Date
Since this AD action does not affect any airplane that is currently on the U.S. register, it has no adverse economic impact and imposes no additional burden on any person. Therefore, prior notice and public procedures hereon are unnecessary and the amendment may be made effective in less than 30 days after publication in the Federal Register.
Comments Invited
Although this action is in the form of a final rule and was not preceded by notice and opportunity for public comment, comments are invited on this rule. Interested persons are invited to comment on this rule by submitting such written data, views, or arguments as they may desire. Communications shall identify the Rules Docket numberand be submitted in triplicate to the address specified under the caption "ADDRESSES." All communications received on or before the closing date for comments will be considered, and this rule may be amended in light of the comments received. Factual information that supports the commenter's ideas and suggestions is extremely helpful in evaluating the effectiveness of the AD action and determining whether additional rulemaking action would be needed.
Comments are specifically invited on the overall regulatory, economic, environmental, and energy aspects of the rule that might suggest a need to modify the rule. All comments submitted will be available, both before and after the closing date for comments, in the Rules Docket for examination by interested persons. A report that summarizes each FAA-public contact concerned with the substance of this AD will be filed in the Rules Docket.
Commenters wishing the FAA to acknowledge receipt of their comments submitted in response tothis rule must submit a self-addressed, stamped postcard on which the following statement is made: "Comments to Docket Number 98-NM-48-AD." The postcard will be date stamped and returned to the commenter.
Regulatory Impact
The regulations adopted herein will not have substantial direct effects on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government. Therefore, in accordance with Executive Order 12612, it is determined that this final rule does not have sufficient federalism implications to warrant the preparation of a Federalism Assessment.
For the reasons discussed above, I certify that this action (1) is not a "significant regulatory action" under Executive Order 12866; (2) is not a "significant rule" under DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and (3) will not have a significant economic impact, positive or negative,on a substantial number of small entities under the criteria of the Regulatory Flexibility Act. A final evaluation has been prepared for this action and it is contained in the Rules Docket. A copy of it may be obtained from the Rules Docket at the location provided under the caption "ADDRESSES."
List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety.
Adoption of the Amendment
Accordingly, pursuant to the authority delegated to me by the Administrator, the Federal Aviation Administration amends part 39 of the Federal Aviation Regulations (14 CFR part 39) as follows:
PART 39 - AIRWORTHINESS DIRECTIVES
1. The authority citation for part 39 continues to read as follows: Authority: 49 U.S.C. 106(g), 40113, 44701. 39.13 [Amended]
2. Section 39.13 is amended by adding the following new airworthiness directive: