AD 94-24-06

This amendment adopts a new airworthiness directive (AD), applicable to all Raytheon Corporate Jets Model BH/HS 125-600A and -700A series airplanes, that requires installation of two new circuit breakers in the 6 volt output circuits of the flight deck lighting transformers on electrical Panel 'RY,' below the right pilot's seat. This amendment is prompted by a report of smoke in the flight deck due to a lighting transformer 6 volt output circuit short circuiting to ground. The actions specified by this AD are intended to prevent smoke or fire in the flight deck due to inadequate circuit protection for 6 volt circuits of the flight deck lighting transformer.

Final rule.

94-24-06 RAYTHEON CORPORATE JETS, INC. (FORMERLY DEHAVILLAND, HAWKER SIDDLEY, BRITISH AEROSPACE PLC): Amendment 39-9079. Docket 94-NM-74-AD.

Applicability: All Model BH/HS 125-600A and -700A series airplanes, certificated in any category.

NOTE 1: This AD applies to each airplane identified in the preceding applicability provision, regardless of whether it has been modified, altered, or repaired in the area subject to the requirements of this AD. For airplanes that have been modified, altered, or repaired so that the performance of the requirements of this AD is affected, the owner/operator must use the authority provided in paragraph (b) to request approval from the FAA. This approval may address either no action, if the current configuration eliminates the unsafe condition; or different actions necessary to address the unsafe condition described in this AD. Such a request should include an assessment of the effect of the changed configuration on the unsafe condition addressed by this AD. In no case does the presence of any modification, alteration, or repair remove any airplane from the applicability of this AD.

Compliance: Required as indicated, unless accomplished previously.

To prevent smoke or fire in the flight deck due to short circuiting of the flight deck lighting transformers 6V output circuits, accomplish the following:

(a) Within six months after the effective date of this AD, install circuit breakers in two 6 volt output circuits of the flight deck lighting transformers in accordance with Hawker - Raytheon Corporate Jets Service Bulletin SB.24-310-3544A&B, dated February 14, 1994.

(b) An alternative method of compliance or adjustment of the compliance time that provides an acceptable level of safety may be used if approved by the Manager, Standardization Branch, ANM-113, FAA, Transport Airplane Directorate. Operators shall submit their requests through an appropriate FAA Principal Maintenance Inspector, who mayadd comments and then send it to the Manager, Standardization Branch, ANM-113.

NOTE 2: Information concerning the existence of approved alternative methods of compliance with this AD, if any, may be obtained from the Standardization Branch, ANM-113.

(c) Special flight permits may be issued in accordance with sections 21.197 and 21.199 of the Federal Aviation Regulations (14 CFR 21.197 and 21.199) to operate the airplane to a location where the requirements of this AD can be accomplished.

(d) The installation shall be done in accordance with Hawker - Raytheon Corporate Jets Service Bulletin SB.24-310-3544A&B, dated February 14, 1994. This incorporation by reference was approved by the Director of the Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR part 51. Copies may be obtained from Raytheon Corporate Jets, Inc., Customer Support Department, Adams Field, P.O. Box 3356, Little Rock, Arkansas 72203. Copies may be inspected at the FAA, Transport AirplaneDirectorate, 1601 Lind Avenue, SW., Renton, Washington; or at the Office of the Federal Register, 800 North Capitol Street, NW., suite 700, Washington, DC.

(e) This amendment becomes effective on January 4, 1995.

A proposal to amend part 39 of the Federal Aviation Regulations (14 CFR part 39) to include an airworthiness directive (AD) that is applicable to all Raytheon Corporate Jets Model BH/HS 125-600A and -700A series airplanes was published in the Federal Register on July 27, 1994 (59 FR 38143). That action proposed to require installation of two new circuit breakers in the 6 volt output circuits of the flight deck lighting transformers on electrical Panel 'RY,' below the right pilot's seat.

Interested persons have been afforded an opportunity to participate in the making of this amendment. No comments were submitted in response to the proposal or the FAA's determination of the cost to the public.

As a result of recent communications with the Air Transport Association (ATA) of America, the FAA has learned that, in general, some operators may misunderstand the legal effect of AD's on airplanes that are identified in the applicability provision of the AD, but that have been altered or repaired in the area addressed by the AD. Under these circumstances, at least one operator appears to have incorrectly assumed that its airplane was not subject to an AD. On the contrary, all airplanes identified in the applicability provision of an AD are legally subject to the AD. If an airplane has been altered or repaired in the affected area in such a way as to affect compliance with the AD, the owner or operator is required to obtain FAA approval for an alternative method of compliance with the AD, in accordance with the paragraph of each AD that provides for such approvals. A note has been added to this final rule to clarify this requirement. The FAA has determined that this addition will neither increase the economic burden on any operator nor increase the scope of the AD.

The FAA estimates that 202 airplanes of U.S. registry will be affected by this AD, that it will take approximately 10 work hours per airplane to accomplish the required actions, and that the average labor rate is $60 per work hour. Required parts will cost approximately $500 per airplane. Based on these figures, the total cost impact of the AD on U.S. operators is estimated to be $222,200, or $1,100 per airplane.

The total cost impact figure discussed above is based on assumptions that no operator has yet accomplished any of the requirements of this AD action, and that no operator would accomplish those actions in the future if this AD were not adopted.

The regulations adopted herein will not have substantial direct effects on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government. Therefore, in accordance with Executive Order 12612, it is determined that this final rule does not have sufficient federalism implications to warrant the preparation of a Federalism Assessment.

For the reasons discussed above, I certifythat this action (1) is not a "significant regulatory action" under Executive Order 12866; (2) is not a "significant rule" under DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and (3) will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act. A final evaluation has been prepared for this action and it is contained in the Rules Docket. A copy of it may be obtained from the Rules Docket at the location provided under the caption "ADDRESSES."

List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety.

Adoption of the Amendment
Accordingly, pursuant to the authority delegated to me by the Administrator, the Federal Aviation Administration amends part 39 of the Federal Aviation Regulations (14 CFR part 39) as follows:

PART 39 - AIRWORTHINESS DIRECTIVES
1. The authority citation for part 39 continues to read as follows:
Authority: 49 U.S.C. App. 1354(a), 1421 and 1423; 49 U.S.C. 106(g); and 14 CFR 11.89.

39.13 - [Amended]
2. Section 39.13 is amended by adding the following new airworthiness directive: