AD 78-23-01

Active

Fuel Drain Assembly

Key Information
78-23-01
Active
November 03, 1978
October 20, 1978
Unknown
39-3330
Applicability
["Aircraft"]
["Small Airplane"]
Piper Aircraft Inc.
PA-28-235 PA-32-260 PA-32-300 PA-32R-300 PA-32RT-300 PA-32RT-300T PA-32S-300
Regulatory Text

78-23-01 PIPER AIRCRAFT CORPORATION: Amendment 39-3330. Applies to Models PA-28-235, PA-32-260, PA-32-300, PA-32S-300, PA-32R-300, PA-32RT-300 and PA- 32RT-300T airplanes, certificated in all categories.

Compliance is required as indicated.

To prevent inadvertent fuel drain lever actuation, accomplish the following:

(a) On Model PA-28-235 serial numbers 28-10003 through 28-10660, accomplish the following:

(1) Within the next 50 hours time in service after the effective date of this AD, unless already accomplished, remove the fuel drain lever cover assembly Piper Part Number 65196-05, -06, or -07.

(2) Remove snap studs from spar box if installed.

(3) Using existing stud holes in spar box, install new drain cover assembly, Piper Kit 763 883V.

(4) Actuate fuel drain valve handle and insure adequate clearance between the handle and cover assembly.

(5) Make appropriate maintenance record entry.

(b) On Models PA-28-235, PA-32-260, PA-32-300, PA-32S-300, PA-32R-300, PA-32RT-300, and PA-32RT-300T, all serial numbers, accomplish the following:

(1) For airplanes with 300 hours or more time in service, within the next 50 hours time in service from the effective date of this AD, and at intervals not to exceed 100 hours time in service from the last check, check the fuel drain lever cover assembly door to determine whether the door freely opens and closes freely without manual assistance and prevents actuation of the lever when the door is in the closed position.

(2) If the door does not open and close freely or if the door does not prevent access to the lever when it is in the closed position, replace the fuel drain lever cover assembly with a serviceable assembly, and make the appropriate maintenance record entry.

(3) If the door opens and closes freely and prevents access to the lever when it is in the closed position, make the appropriate maintenance record entry.

(c) An alternate method of compliance may be approved by the Chief, Engineering and Manufacturing Branch, Federal Aviation Administration, Southern Region.

The checks in this AD may be accomplished by the pilot and appropriate maintenance record entries made in accordance with FAR 91.173. Replacement must be accomplished by a person authorized by FAR 43.3.

(Piper Service Letter 856 dated September 15, 1978, pertains to paragraph (a).)

This amendment becomes effective November 3, 1978.

AD Assistant

Get AI-powered answers about this AD, check applicability, and find compliance steps.

Sign Up to Unlock
References
This information is not available.
--- - Part 39
--- - _EMPTY_
Issuing Office
["AIR-720: Operational Safety Branch"]
FAA Documents