AD 76-18-04

Active

Fuel Valve

Key Information
76-18-04
Active
September 10, 1976
August 24, 1976
Unknown
39-2709
Applicability
["Aircraft"]
["Small Airplane"]
Piper Aircraft Inc.
PA-28-235 PA-32-260 PA-32-300 PA-32R-300
Regulatory Text

76-18-04 PIPER AIRCRAFT CORPORATION: Amendment 39-2709. Applies to PA-28-235, serial numbers 28-10001 through 28-7610157, equipped with Airborne fuel valve 1-H65- 2, Piper part number 492 259; PA-32-260 serial numbers 32-1 through 32-7600020 equipped with Airborne fuel valve Model 1-H65-2, Piper part number 492 259; PA-32-300 serial numbers 32-40000 through 32-7640109 equipped with Airborne fuel valve Model 1-H65-2, Piper part number 492 259; PA-32R-300 serial numbers 32R-7680001 through 32R-7680423 equipped with Airborne fuel valve Model 1-H65-3, Piper part number 492 262; certificated in all categories.

Compliance required within the next ten hours' time in service after the effective date of this AD, unless already accomplished.

To prevent fuel valve inner port leakage, accomplish the following:

I. Perform the following checks:

1. Fill all fuel tanks to capacity.

2. Actuate the fuel selector valve quick drain handle a minimum of three (3) times. Insure that the handle is actuated through its full travel and release slowly each time.

3. Start engine and run at a 1000 R.P.M. setting with electric fuel pump on.

4. Place fuel selector valve in the OFF position.

5. Continue to run the engine at 1000 R.P.M. until fuel has been exhausted and not to exceed the seven (7) minute duration.

If fuel exhaustion occurs and the engine quits within the seven (7) minute running period, make an appropriate log book entry.

The checks required by this AD may be performed by the pilot. For the requirements regarding the listing of compliance and method of compliance with this AD in the airplane's maintenance record, see FAR 91.173.

II. If the engine continues to run for the full seven (7) minute period, replace the fuel selector valve with the appropriate serviceable fuel valve and repeat Paragraph I.

An equivalent means of compliance with this AD must be approved by the Chief, Engineering and Manufacturing Branch, Federal Aviation Administration, Southern Region.

Piper Service Bulletin No. 519 also pertains to this same subject.

This amendment becomes effective September 10, 1976.

AD Assistant

Get AI-powered answers about this AD, check applicability, and find compliance steps.

Sign Up to Unlock
References
This information is not available.
--- - Part 39
--- - _EMPTY_
Issuing Office
["AIR-720: Operational Safety Branch"]
FAA Documents