51-29-02 CURTISS-WRIGHT: Applies to all Model C-46 Series aircraft.
Compliance required by February 1, 1952, and each 500 hours thereafter.
Inspect the main landing gear side brace attachment fittings, P/N 20-310-1033 L and R, for cracks particularly from the edge of the forging to the lower inboard attaching bolt hole. If defects are found, the parts should be replaced by undamaged parts.
In view of unavailability of parts and controlled inspection procedures under which satisfactory operation has existed, it will be considered satisfactory to operate the aircraft with a cracked fitting under the following procedure until further notice. Inspect at periodic intervals not to exceed 150 hours with approximately an 8-power magnifying glass or dye penetrant or any equivalent method. If cracks extend beyond bolt hole, either through or around the hole, the fitting must be replaced.